NCCCO TEST 2 (ACTUAL 2025) QUESTIONS WITH
CORRECT VERIFIED ANSWERS
If not listed in the load/capacity charts for a hydraulic crane,
and you are in between boom lengths, you should:
Use the next longer length or shorter with less capacity
When a spinning load presents a danger, the operator should:
Use a tagline
The jib capacity is 8 tons and the ball weighs 900 lbs. What is
the heaviest load that can be lifted safely?
15,100
Parts of line means:
The number of lines running thru the load block
If a jib is erected but not being used, it is treated as a
deduction from the cranes:
, Gross capacity
What is the maximum number of broken wires before
replacement on a standing wire rope?
2
What are most jibs capacities based on?
Structural
On the majority of conventional cranes, the power is
transferred to the torque converter by a:
Master clutch
During disassembly of a long boom, the hog lines are
connected at the maximum cantilever point and the boom is
slightly lifted off the ground. Which pins are to be removed
next?
The bottom pins ahead of the cantilever point
CORRECT VERIFIED ANSWERS
If not listed in the load/capacity charts for a hydraulic crane,
and you are in between boom lengths, you should:
Use the next longer length or shorter with less capacity
When a spinning load presents a danger, the operator should:
Use a tagline
The jib capacity is 8 tons and the ball weighs 900 lbs. What is
the heaviest load that can be lifted safely?
15,100
Parts of line means:
The number of lines running thru the load block
If a jib is erected but not being used, it is treated as a
deduction from the cranes:
, Gross capacity
What is the maximum number of broken wires before
replacement on a standing wire rope?
2
What are most jibs capacities based on?
Structural
On the majority of conventional cranes, the power is
transferred to the torque converter by a:
Master clutch
During disassembly of a long boom, the hog lines are
connected at the maximum cantilever point and the boom is
slightly lifted off the ground. Which pins are to be removed
next?
The bottom pins ahead of the cantilever point
