ASE A5 Brakes Automotive Certification Test 2025/2026 With Questions and Answers/ Graded A+

ASE A5 Brakes Automotive Certification Test 2025/2026 With Questions and Answers/ Graded A+ The brakes are being bled on an older vehicle equipped with a quick take up valve in the master cylinder. Technician A says the quick take up valve must be depressed. Technician B says the brakes on this vehicle cannot be bled. Who is right? a. A only b. B only c. Both A and B d. Neither A nor B Both technicians are wrong. The brakes on quick take up systems use the same bleeding procedure as those without this valve. A spongy brake pedal may be caused by: a. ABS Diagnostic Trouble Code set b. Frozen caliper piston c. Defective metering valve. d. Air in hydraulic system Air causes a gap in the hydraulic fluid flow because the fluid has to compress theair before it can apply the piston. This delay causes the spongy feel. The other choices do not affect this concern. This question has the word EXCEPT. For this question, look for the choice that could NOT cause the described situation. Read the entire question carefully before choosing your answer. A vehicle has a very erratic brake pulling concern while applying the brakes. All of the following items could cause this erratic pull EXCEPT: a. Excessive tire pressure b. Four-wheel alignment c. Seized caliper piston on the other side d. Steering gear problem Excessive tire pressure is the exception because this fault will cause tire wear but not a pull. Low or uneven tire pressure can cause a pull. A power assist brake booster push rod that is to short will cause which of the following? a. Excessive brake drag b. Brake system to be inoperative c. Excessive brake pedal travel d. Brake light is illuminated