MICHIGAN STATE BRAKES LATEST UPDATES
CERTIFICATION EXAM ACTUAL QUESTIONS AND
CORRECT ANSWERS ALREADY GRADED A+
GUARANTEED SUCCESS
A mechanic finds gear lube inside both rear brake drums on a rear wheel drive
vehicle. What is the most likely cause of this problem?
A plugged axle
When turning brake drums:
use a dampening strap to reduce chatter
Which of the following is NOT a necessary drum brake measurement?
run-out
On a 3-channel system, which wheels are on the same circuit?
both rear wheels
Which of the following incorrect service procedures will cause brake lock-up?
master cylinder push rod adjusted too long
Which of the following describes the proper way to depressurized an ABS system?
Pump the brake pedal at least 25 times (or more, depending on the manufacturer's
recommendation) with the ignition off.
The rear brakes are dragging after having new linings installed and the drums
machined. the most likely cause is the:
, technician use the parking brake to adjust shoes and the cable is stuck
One way to test an ABS wheel speed signal is to use _____ on your digital
multimeter.
AC volts
The key input for the ABS control module comes from the:
wheel speed sensors
ABS speed sensor and sensor rings:
should not be hammered or tapped on and should always be replaced as a matched
set
Flexible brake hoses should be replaced:
when dampness is evident on the hose
Which of the following should be used to check for rotor thickness variation:
Micrometer
After rebuilding a master cylinder, the rod between the master cylinder and booster
should be:
adjusted properly
Upon inspecting brake fluid condition, the technician observes the diaphragm in the
master cylinder cup is swollen. Which of the following is the most likely cause?
silicone fluid added to the system
When inspecting brake fluid levels, a technician observes low fluid levels. which of
the following should be done first?
Inspect disc brake pads for excessive wear
Which of the following is true about most properly functioning anti-lock brake
systems?
The brakes may lock up at speeds less than 10 miles per hour
Which of the following is true about bleeding brake lines on most ABS equipped
vehicles?
CERTIFICATION EXAM ACTUAL QUESTIONS AND
CORRECT ANSWERS ALREADY GRADED A+
GUARANTEED SUCCESS
A mechanic finds gear lube inside both rear brake drums on a rear wheel drive
vehicle. What is the most likely cause of this problem?
A plugged axle
When turning brake drums:
use a dampening strap to reduce chatter
Which of the following is NOT a necessary drum brake measurement?
run-out
On a 3-channel system, which wheels are on the same circuit?
both rear wheels
Which of the following incorrect service procedures will cause brake lock-up?
master cylinder push rod adjusted too long
Which of the following describes the proper way to depressurized an ABS system?
Pump the brake pedal at least 25 times (or more, depending on the manufacturer's
recommendation) with the ignition off.
The rear brakes are dragging after having new linings installed and the drums
machined. the most likely cause is the:
, technician use the parking brake to adjust shoes and the cable is stuck
One way to test an ABS wheel speed signal is to use _____ on your digital
multimeter.
AC volts
The key input for the ABS control module comes from the:
wheel speed sensors
ABS speed sensor and sensor rings:
should not be hammered or tapped on and should always be replaced as a matched
set
Flexible brake hoses should be replaced:
when dampness is evident on the hose
Which of the following should be used to check for rotor thickness variation:
Micrometer
After rebuilding a master cylinder, the rod between the master cylinder and booster
should be:
adjusted properly
Upon inspecting brake fluid condition, the technician observes the diaphragm in the
master cylinder cup is swollen. Which of the following is the most likely cause?
silicone fluid added to the system
When inspecting brake fluid levels, a technician observes low fluid levels. which of
the following should be done first?
Inspect disc brake pads for excessive wear
Which of the following is true about most properly functioning anti-lock brake
systems?
The brakes may lock up at speeds less than 10 miles per hour
Which of the following is true about bleeding brake lines on most ABS equipped
vehicles?
