HIC virginia Exam Questions With Complete Solutions
A ______ wall is a masonry outer non-weight bearing wall that
is not braced at each story. Correct Answers Curtain
A deck attached to the back of a house is framed with southern
pine 2x10s. The joists are 16 inches OC. What is the maximum
allowable clear span for the joists supporting this deck? Correct
Answers 14 feet 0 inches
A handrail must be provided on at least one side of all ramps
exceeding a slope of one unit vertical in units horizontal.
Correct Answers 12
A minimum temperature of ___ should be maintained during
gypsum board application. Correct Answers 50°F
A nosing projection not less than inch(es) but not more than
inch(es) must be provided on stairways with solid risers.
Correct Answers 3/4, 1-1/4
According to Carpentry & Building Construction, what is the
standard height of an interior door? Correct Answers 6'-8"
All emergency escape and rescue openings must have a
minimum net clear opening height of inches. Correct Answers
24
Anchor bolts should be spaced no more than __' apart and no
more than __" from the ends of any plate section or wall corner.
, Each bolt must extend at least __" into the concrete. Correct
Answers 6, 12, 7
Asphalt shingles shall only be used on roof slopes of units
vertical in 12 units horizontal or greater. Correct Answers 2
Building address numbers shall be Arabic numbers or
alphabetical letters. Numbers shall be a minimum of high with a
minimum stroke width of Correct Answers 4 inches, 1/2 inch
For 2X6 framed walls to achieve an R-value of R-20,
pneumatically applied insulation must be at least __. Correct
Answers Find section for Sidewalls, R-20 = 5.5 inches.
Garage floor surfaces must be made of approved Correct
Answers noncombustible
Gypsum products should be stored ___ in a shed or outbuilding.
Correct Answers Stacked flat
Handrails on a ramp adjacent to a wall must have a space of not
less than inches between the wall and the handrails. Correct
Answers 1.5
How should ceiling insulation be installed? Correct Answers
Ceiling insulation should not extend over the top of the plate of
the outside wall.
If butt joints occur when applying gypsum panels to wood and
steel framing stagger and locate them as far from the ___ of
walls and ceilings as possible. Correct Answers Center
A ______ wall is a masonry outer non-weight bearing wall that
is not braced at each story. Correct Answers Curtain
A deck attached to the back of a house is framed with southern
pine 2x10s. The joists are 16 inches OC. What is the maximum
allowable clear span for the joists supporting this deck? Correct
Answers 14 feet 0 inches
A handrail must be provided on at least one side of all ramps
exceeding a slope of one unit vertical in units horizontal.
Correct Answers 12
A minimum temperature of ___ should be maintained during
gypsum board application. Correct Answers 50°F
A nosing projection not less than inch(es) but not more than
inch(es) must be provided on stairways with solid risers.
Correct Answers 3/4, 1-1/4
According to Carpentry & Building Construction, what is the
standard height of an interior door? Correct Answers 6'-8"
All emergency escape and rescue openings must have a
minimum net clear opening height of inches. Correct Answers
24
Anchor bolts should be spaced no more than __' apart and no
more than __" from the ends of any plate section or wall corner.
, Each bolt must extend at least __" into the concrete. Correct
Answers 6, 12, 7
Asphalt shingles shall only be used on roof slopes of units
vertical in 12 units horizontal or greater. Correct Answers 2
Building address numbers shall be Arabic numbers or
alphabetical letters. Numbers shall be a minimum of high with a
minimum stroke width of Correct Answers 4 inches, 1/2 inch
For 2X6 framed walls to achieve an R-value of R-20,
pneumatically applied insulation must be at least __. Correct
Answers Find section for Sidewalls, R-20 = 5.5 inches.
Garage floor surfaces must be made of approved Correct
Answers noncombustible
Gypsum products should be stored ___ in a shed or outbuilding.
Correct Answers Stacked flat
Handrails on a ramp adjacent to a wall must have a space of not
less than inches between the wall and the handrails. Correct
Answers 1.5
How should ceiling insulation be installed? Correct Answers
Ceiling insulation should not extend over the top of the plate of
the outside wall.
If butt joints occur when applying gypsum panels to wood and
steel framing stagger and locate them as far from the ___ of
walls and ceilings as possible. Correct Answers Center
