AUTOBODY Exam Questions and
Answers Latest 2025 Top Rated A+
Technician A says that a unibody structure directly affects vehicle
wheel alignment. Technician B says that a vehicle's unibody structure
does not affect vehicle wheel alignment. Who is correct?
Ans: technician A
Which of the following are designed to stiffen a unibody structure?
,2 |Page
Ans: cross members and bracing
Technician A gives a more thorough damage analysis to a unibody
vehicle than to a conventional frame vehicle. Technician B says the
conventional frame vehicle requires the more thorough inspection.
Who is correct?
Ans: technician A
Which type of steel is most often used in new vehicle structural
components?
Ans: high strength steel
A dented panel cannot be accessed from the rear for straightening
with a hammer and dolly. Technician A says to drill holes in the panel
and use screws to pull out the damaged sheet metal. Technician B
says to avoid drilling holes in panels, because this will damage the
panel and its corrosion resistance. Who is correct?
, Ans: technician B
An object has hit a fender and placed a dent in it. Technician A says
to hit the center of the dent from the back with a dolly first to drive
out the deepest part of the dent. Technician B says to use a dolly
and hammer to work the dent out, starting at the perimeter and
working inward to the deepest part of the dent last. Who is correct?
Ans: technician B
Which kind of spoon can be used instead of a hammer?
Ans: slapping spoon
Technician A says that aluminum has a lower melting point than
steel. Technician B says that you should use a temperature-sensitive
crayon when heating aluminum since it does not glow cherry-red
right before it melts. Who is correct?
Answers Latest 2025 Top Rated A+
Technician A says that a unibody structure directly affects vehicle
wheel alignment. Technician B says that a vehicle's unibody structure
does not affect vehicle wheel alignment. Who is correct?
Ans: technician A
Which of the following are designed to stiffen a unibody structure?
,2 |Page
Ans: cross members and bracing
Technician A gives a more thorough damage analysis to a unibody
vehicle than to a conventional frame vehicle. Technician B says the
conventional frame vehicle requires the more thorough inspection.
Who is correct?
Ans: technician A
Which type of steel is most often used in new vehicle structural
components?
Ans: high strength steel
A dented panel cannot be accessed from the rear for straightening
with a hammer and dolly. Technician A says to drill holes in the panel
and use screws to pull out the damaged sheet metal. Technician B
says to avoid drilling holes in panels, because this will damage the
panel and its corrosion resistance. Who is correct?
, Ans: technician B
An object has hit a fender and placed a dent in it. Technician A says
to hit the center of the dent from the back with a dolly first to drive
out the deepest part of the dent. Technician B says to use a dolly
and hammer to work the dent out, starting at the perimeter and
working inward to the deepest part of the dent last. Who is correct?
Ans: technician B
Which kind of spoon can be used instead of a hammer?
Ans: slapping spoon
Technician A says that aluminum has a lower melting point than
steel. Technician B says that you should use a temperature-sensitive
crayon when heating aluminum since it does not glow cherry-red
right before it melts. Who is correct?
