Page | 1
AWS-CWI Part B Test 6 Questions and
Answers (Expert Solutions)
Q: The length of a fillet weld is the _______________________., 🗹🗹: Overall length of the
full size fillet.
Q: The incomplete filling of the weld root is called __________________., 🗹🗹: Inadequate
penetration.
Q: To zero out the dial caliper, you have to perform what function?, 🗹🗹: Close the
jaws or contact points to no opening.
Locate the notch in the face plate and rotate it until the needle comes to zero.
Q: Edges of members not subject to calculated stresses shall have no gouges deeper
than, 🗹🗹: 1/8"
Q: Weld crown in pipeline applications may also be referred to as:, 🗹🗹: Weld
reinforcement
Q: What is the acceptable amount of misalignment (hi-low) for pressure piping?,
🗹🗹: 0.0625" or 1/16"
Q: What is the abbreviation for nondestructive testing?, 🗹🗹: NDT
Q: What formula would you use to convert pounds per square inch to Megapascals?,
🗹🗹: PSI X 0.00689 = MPa
Q: CVN (Charpy V Notch) testing shall conform to _______________., 🗹🗹: AWS B4.0
AWS-CWI Part B Test 6 Questions and
Answers (Expert Solutions)
Q: The length of a fillet weld is the _______________________., 🗹🗹: Overall length of the
full size fillet.
Q: The incomplete filling of the weld root is called __________________., 🗹🗹: Inadequate
penetration.
Q: To zero out the dial caliper, you have to perform what function?, 🗹🗹: Close the
jaws or contact points to no opening.
Locate the notch in the face plate and rotate it until the needle comes to zero.
Q: Edges of members not subject to calculated stresses shall have no gouges deeper
than, 🗹🗹: 1/8"
Q: Weld crown in pipeline applications may also be referred to as:, 🗹🗹: Weld
reinforcement
Q: What is the acceptable amount of misalignment (hi-low) for pressure piping?,
🗹🗹: 0.0625" or 1/16"
Q: What is the abbreviation for nondestructive testing?, 🗹🗹: NDT
Q: What formula would you use to convert pounds per square inch to Megapascals?,
🗹🗹: PSI X 0.00689 = MPa
Q: CVN (Charpy V Notch) testing shall conform to _______________., 🗹🗹: AWS B4.0
