04/08/2025, 12:15 STATE BRAKE CERTIFICATION (2025) EXAM QUESTIONS AND ALL CORRECT ANSWERS 100% SOLVED AND GUARANTE…
STATE BRAKE CERTIFICATION (2025) EXAM
QUESTIONS AND ALL CORRECT ANSWERS 100%
SOLVED AND GUARANTEED SUCCESS!!
Save
Terms in this set (33)
A cracked or torn vacuum a hard pedal feel requiring very high pedal effort to
diaphragm in a brake stop
power booster would
most likely cause:
to test a vacuum power drop slightly and remain firm
brake booster in the
vehicle, you should pump
the brake pedal at least 4
times, hold the brake
pedal depressed, and
start the engine. the brake
pedal should:
A mechanic finds gear a plugged axle
lube inside both rear
drums on a rear wheel
drive vehicle. What is most
likely the cause of this
problem?
https://quizlet.com/1063799552/state-brake-certification-2025-exam-questions-and-all-correct-answers-100-solved-and-guaranteed-success-flash-card… 1/5
, 04/08/2025, 12:15 STATE BRAKE CERTIFICATION (2025) EXAM QUESTIONS AND ALL CORRECT ANSWERS 100% SOLVED AND GUARANTE…
The rear brakes are technician use the parking brake to adjust shoes and
dragging after having new the cable is stuck
linings installed and the
drums machined. the most
likely cause is the:
While test driving a car, brake fluid or grease on the brake linings
the mechanic finds that
the right front brake
"grabs". The most likely
cause of this problem is:
Which of the following master cylinder push rod adjusted too long
incorrect service
procedures will cause
brake lock-up?
Which of the following incorrect run-out on the car brake lathe
incorrect service
procedures could cause
brake pedal pulsation?
A common cause of pedal NOT caused by improperly torqued wheels, damaged
pulsation during brake backing plates, or lubricated shims
application is:
A properly functioning cause an increase in the hydraulic pressure during
load sensing braking at the rear wheel cylinders when the vehicle is
proportioning valve will: loaded.
which of the following is a pump up the brake pedal, then hold it firm. if the
quick way to isolated a pedal slowly drops to the floor, the master cylinder
defective master cylinder? may be defective.
There are no external
leaks in the system.
After rebuilding a master adjusted properly
cylinder, the rod between
the master cylinder and
booster should be:
https://quizlet.com/1063799552/state-brake-certification-2025-exam-questions-and-all-correct-answers-100-solved-and-guaranteed-success-flash-card… 2/5
STATE BRAKE CERTIFICATION (2025) EXAM
QUESTIONS AND ALL CORRECT ANSWERS 100%
SOLVED AND GUARANTEED SUCCESS!!
Save
Terms in this set (33)
A cracked or torn vacuum a hard pedal feel requiring very high pedal effort to
diaphragm in a brake stop
power booster would
most likely cause:
to test a vacuum power drop slightly and remain firm
brake booster in the
vehicle, you should pump
the brake pedal at least 4
times, hold the brake
pedal depressed, and
start the engine. the brake
pedal should:
A mechanic finds gear a plugged axle
lube inside both rear
drums on a rear wheel
drive vehicle. What is most
likely the cause of this
problem?
https://quizlet.com/1063799552/state-brake-certification-2025-exam-questions-and-all-correct-answers-100-solved-and-guaranteed-success-flash-card… 1/5
, 04/08/2025, 12:15 STATE BRAKE CERTIFICATION (2025) EXAM QUESTIONS AND ALL CORRECT ANSWERS 100% SOLVED AND GUARANTE…
The rear brakes are technician use the parking brake to adjust shoes and
dragging after having new the cable is stuck
linings installed and the
drums machined. the most
likely cause is the:
While test driving a car, brake fluid or grease on the brake linings
the mechanic finds that
the right front brake
"grabs". The most likely
cause of this problem is:
Which of the following master cylinder push rod adjusted too long
incorrect service
procedures will cause
brake lock-up?
Which of the following incorrect run-out on the car brake lathe
incorrect service
procedures could cause
brake pedal pulsation?
A common cause of pedal NOT caused by improperly torqued wheels, damaged
pulsation during brake backing plates, or lubricated shims
application is:
A properly functioning cause an increase in the hydraulic pressure during
load sensing braking at the rear wheel cylinders when the vehicle is
proportioning valve will: loaded.
which of the following is a pump up the brake pedal, then hold it firm. if the
quick way to isolated a pedal slowly drops to the floor, the master cylinder
defective master cylinder? may be defective.
There are no external
leaks in the system.
After rebuilding a master adjusted properly
cylinder, the rod between
the master cylinder and
booster should be:
https://quizlet.com/1063799552/state-brake-certification-2025-exam-questions-and-all-correct-answers-100-solved-and-guaranteed-success-flash-card… 2/5
