Louisiana Contractor's License Exam Prep - Sample Questions
1. Plumb When a vertical wall is correctly installed, it is
2. 24 inches Depth of a standard closet
3. 30 inches Minimum clearance in an attic
4. R12 Minimum insulation on a water heater
5. 42 inches Minimum rail height on a scattolding
6. Friable When is asbestos most dangerous
7. Largest The smallest wire gauge has the number?
8. 36 inches Height of standard kitchen cabinets
9. 28 inches A one-story building has a minimum foundation depth of
10. No. 28 Minimum gauge for galvanized steel valley flashing
11. 2,500psi Minimum compression strength in PSI for a concrete basement slab,
12. 3,000sf Accessory structures are no greater than SF
13. R19 R value requirement in Zone 3
14. 32 inches Minimum width for a means of egress door
15. 3 Exterior wood framing shall be a minimum of grade wood
16. 50psf Live loads for floors and roofs must be posted when they exceed pdf
1/1
1. Plumb When a vertical wall is correctly installed, it is
2. 24 inches Depth of a standard closet
3. 30 inches Minimum clearance in an attic
4. R12 Minimum insulation on a water heater
5. 42 inches Minimum rail height on a scattolding
6. Friable When is asbestos most dangerous
7. Largest The smallest wire gauge has the number?
8. 36 inches Height of standard kitchen cabinets
9. 28 inches A one-story building has a minimum foundation depth of
10. No. 28 Minimum gauge for galvanized steel valley flashing
11. 2,500psi Minimum compression strength in PSI for a concrete basement slab,
12. 3,000sf Accessory structures are no greater than SF
13. R19 R value requirement in Zone 3
14. 32 inches Minimum width for a means of egress door
15. 3 Exterior wood framing shall be a minimum of grade wood
16. 50psf Live loads for floors and roofs must be posted when they exceed pdf
1/1
