Recent Version Comprehensive 100 Questions
and Verified Answers Accurate Solutions Already
Graded A+ Get it 100% Correct
a lifting pad must be in place to lift a BMW vehicle, T or F? - CORRECT ANSWER: True
A technician should consider which of the following questions for a quality control
process after performing service work to a vehicle?
Did I address all concerns?
Did I top off all fluids and set tire pressure?
Did I reset service lights?
All of the above - CORRECT ANSWER: All of the above
According to MSDS warning symbols, the warning symbol with a skull and cross bones
shown represents - CORRECT ANSWER: Acute toxicity
All BMW special tools are autoship to the dealer.
True or False? - CORRECT ANSWER: False
All brand new BMW vehicles require a QC1 inspection.
Tech A states that transport Mode should be deleted using ISTA.
Tech B says that transport mode should be deleted using the transport mode switching
device. - CORRECT ANSWER: Both A and B
, All of the following are true concerning the Roundtable, EXCEPT :
There are 12 shows each year.
Each Roundtable has a bulletin describing the topics.
The Roundtable is accessed through AIR.
Each Roundtable has a quiz - CORRECT ANSWER: The Roundtable is accessed
through AIR.
Battery voltage is not critical when performing a voltage drop on a circuit.
True or False? - CORRECT ANSWER: Flase
BMW recommends replacing tire at least every 6 years
what resource can you use to determine that the above statement is correct? -
CORRECT ANSWER: Owners Manual
BMW special took 83 30 0 492 467 can be used during an inspection to measure:
Coolant level
Coolant concentrate
Brake pad thickness and tire thread depth
Air pressure - CORRECT ANSWER: Brake pad thickness and tire thread depth
CPO inspections require a minimum tread depth of 3 mm, as measured from the lowest
area in the tread. T or F? - CORRECT ANSWER: False (from top of wear indicators)
During a CPO inspection, a front brake pad measurement is taken of 4mm on the left
inner pad and 7mm on the left outer pad.