ACTUAL REAL EXAM| COMPLETE FREQUENTLY
TESTED QUESTIONS WITH CORRECT DETAILED
Page | 1
AND VERIFIED ANSWERS| GURANTEED PASS|
TOP RATED A+.
USPA SKYDIVING
Pass the USPA Skydiving A License exam 2025/2026 with confidence. This
exam resource features questions in areas like: parachute deployment,
freefall, canopy control, and landing procedures. This study guide is perfect
for beginner skydivers preparing for independent jumps and A License
certification.
What is the recommended minimum breakoff altitude for free fall groups
of five or fewer? ...... ANSWER ......1,500 feet above the highest planned
deployment altitude
What is the danger of entering a toggle turn too quickly? ...... ANSWER
......line twist
How can you avoid the propeller(s) while approaching an airplane? ......
ANSWER ......approach only from the rear and behind the wing
What is the biggest danger of a hard toggle turn near the ground? ......
ANSWER ......1) Line twist
2) Hard landing while still in a turn
3) Collision with other jumpers
, What should be your first response in the event of a canopy collision and
entanglement with another jumper? ...... ANSWER ......check altitude
Page | 2 and communicate with the other jumper
What should you pay attention to when closing a main container
equipped with a hand deployed pilot chute? ...... ANSWER ......1) Bridle
routing
2) Closing loop tension
3) Flap order
When the brake system uses Velcro, why is it a good idea to place your
toggles back on the Velcro after you land? ...... ANSWER ......To prevent
wear and tear on the lower steering lines
According to the FAA regulations, who may pack a main parachute? ......
ANSWER ......1)A parachute packer under the direct supervision of a
certified parachute rigger
2)A certified parachute rigger
3)The person making the next jump with that parachute
Above 10,000 feet, a jumper should maintain how much horizontal
separation from the clouds? ...... ANSWER ......One mile
Why is it bad to leave a parachute in the sun? ...... ANSWER
......Ultraviolet rays will damage the nylon and weaken the material