,TESTBANK for Motion Simulation and Mechanism
Design with SOLIDWORKS Motion 2025 By Kuang-
Hua Chang
Notes
1- The file is chapter after chapter.
2- We have shown you few pages sample.
3- The file contains all Appendix and Excel sheet
if it exists.
4- We have all what you need, we make update
at every time. There are many new editions
waiting you.
5- If you think you purchased the wrong file You
can contact us at every time, we can replace it
with true one.
6- Test Bank Solutions at the End of the Chapter
Our email:
,Chapter 01 - Introduction to Solidworks Motion
1. Kinematics is the study of motion with regard for the forces that cause the motion.
A) True
B) False
2. For kinematic analysis, the Gruebler’s count must be less than 0 after adding motors.
A) True
B) False
3. An assembly mate defined between two flat faces in SOLIDWORKS is kinematically
equivalent to a slider joint in SOLIDWORKS Motion.
A) True
B) False
4. How many redundant degrees of freedom will we have while assembling a door to a
door frame with one hinge joint?
A) 0
B) 5
C) 3
D) 2
5. Which of the following solver in ADAMS/Solver offer better accuracy for special
problems, such as discontinuous forces?
A) GSTIFF
B) SI2_GSTIFF
C) WSTIFF
D) All of the above
6. Which of the following function button in Motion toolbar allow you to define a motor?
A)
B)
C)
D)
1
, Answer Keys
Question Answer Question Answer
1 B 4 A
2 B 5 C
3 B 6 C
2
Design with SOLIDWORKS Motion 2025 By Kuang-
Hua Chang
Notes
1- The file is chapter after chapter.
2- We have shown you few pages sample.
3- The file contains all Appendix and Excel sheet
if it exists.
4- We have all what you need, we make update
at every time. There are many new editions
waiting you.
5- If you think you purchased the wrong file You
can contact us at every time, we can replace it
with true one.
6- Test Bank Solutions at the End of the Chapter
Our email:
,Chapter 01 - Introduction to Solidworks Motion
1. Kinematics is the study of motion with regard for the forces that cause the motion.
A) True
B) False
2. For kinematic analysis, the Gruebler’s count must be less than 0 after adding motors.
A) True
B) False
3. An assembly mate defined between two flat faces in SOLIDWORKS is kinematically
equivalent to a slider joint in SOLIDWORKS Motion.
A) True
B) False
4. How many redundant degrees of freedom will we have while assembling a door to a
door frame with one hinge joint?
A) 0
B) 5
C) 3
D) 2
5. Which of the following solver in ADAMS/Solver offer better accuracy for special
problems, such as discontinuous forces?
A) GSTIFF
B) SI2_GSTIFF
C) WSTIFF
D) All of the above
6. Which of the following function button in Motion toolbar allow you to define a motor?
A)
B)
C)
D)
1
, Answer Keys
Question Answer Question Answer
1 B 4 A
2 B 5 C
3 B 6 C
2
