TESTBANK for The Complete Guide to Mold Making with SOLIDWORKS 2025 By Paul Tran CSWE

, TESTBANK for The Complete Guide to Mold
Making with SOLIDWORKS 2025 By Paul Tran
CSWE
Notes
1- The file is chapter after chapter.
2- We have shown you few pages sample.
3- The file contains all Appendix and Excel sheet
if it exists.
4- We have all what you need, we make update
at every time. There are many new editions
waiting you.
5- If you think you purchased the wrong file You
can contact us at every time, we can replace it
with true one.
6- Test Bank Solutions at the End of the Chapter
Our email:


, Chapter 01 - Plastic Part Design
1. Draft angle can be added while extruding a sketch.
A) True
B) False

2. Draft angle can be added after the fact, using the Draft tool.
A) True
B) False

3. Adding fillets to the corners and other areas of a plastic part can help strengthen the
features and make it easier to mold.
A) True
B) False

4. Adding the ribs or gussets to a plastic part can help prevent the warping issues.
A) True
B) False

5. The Parting Lines run around the edges of the plastic part, between the core and the
cavity surfaces.
A) True
B) False

6. The Shut-Off surfaces close up all through holes by creating a surface patch along the
edges that forms a continuous loop.
A) True
B) False

7. The Interlock Surface option locks all surfaces in a plastic part to anchor the mold.
A) True
B) False

8. Only one material can be assigned to the plastic part, the core mold, and the cavity
mold.
A) True
B) False




1