ASE G1 PRACTICE TEST QUESTIONS
WITH 100% CORRECT ANSWERS
A technician removes and replaces the lower radiator hose on a four-cylinder engine.
The engine overheats after replacing the hose and adding coolant. Which of these is
MOST likely causing this condition?
A. A faulty ECT sensor
B. A stuck open thermostat
C. An air pocket in the system
D. Electrolysis - Answer-C. An air pocket in the system
The engine mounts were recently replaced on a front-wheel-drive vehicle with
independent suspension. The vehicle now has a steady pull to the left at all speeds.
Technician A says loose motor mounts are causing this pull. Technician B says a
misaligned engine cradle has caused this condition. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-B. Technician B
A vehicle has white-colored exhaust emitted from its tailpipe whenever the engine is
running. Which of the following is MOST likely causing this condition?
A. It has worn piston rings
B. It has a leaking head gasket
C. It has worn valve seals
D. It has a leaking fuel injector - Answer-B. It has a leaking head gasket
An automatic transmission's fluid is pink and milky. Technician A says an overheating
engine causes pink and milky transmission fluid. Technician B says adding too much
transmission fluid to the transmission has caused this condition. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-D. Neither A or B
, Technician A says fuel filters have an arrow that always points toward the fuel tank.
Technician B says a clogged fuel filter reduces fuel pressure at the fuel rail. Who is
correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-B. Technician B
All of the following are true about using a multimeter to test a circuit for continuity
except:
A. Set the multimeter to the Ohms setting
B. Turn the ignition on and power the circuit before testing
C. A reading of OL indicates an open circuit
D. A reading of 0.1 Ohms indicates continuity - Answer-B. Turn the ignition on and
power the circuit before testing
Which of the following is true about the tire in the illustration?
A. It is under-inflated
B. It is over-inflated
C. There is too much camber
D. The coil spring on that wheel is worn - Answer-B. It is over-inflated
An engine is slow cranking. Technician A says there may be resistance in the starter
circuit. Technician B says to perform a voltage drop test to find resistance in a starter
circuit. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-C. Both A and B
Technician A says the illustration above contains two jounce bumpers and two dust
shields. Technician B says jounce bumpers and bump stops protect suspension
components from metal to metal contact. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-C. Both A and B
A technician is unable to balance a tire on a vehicle that vibrates at speeds above 35
mph. Technician A says to continue adding weights around the rim up to 10 ounces.
WITH 100% CORRECT ANSWERS
A technician removes and replaces the lower radiator hose on a four-cylinder engine.
The engine overheats after replacing the hose and adding coolant. Which of these is
MOST likely causing this condition?
A. A faulty ECT sensor
B. A stuck open thermostat
C. An air pocket in the system
D. Electrolysis - Answer-C. An air pocket in the system
The engine mounts were recently replaced on a front-wheel-drive vehicle with
independent suspension. The vehicle now has a steady pull to the left at all speeds.
Technician A says loose motor mounts are causing this pull. Technician B says a
misaligned engine cradle has caused this condition. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-B. Technician B
A vehicle has white-colored exhaust emitted from its tailpipe whenever the engine is
running. Which of the following is MOST likely causing this condition?
A. It has worn piston rings
B. It has a leaking head gasket
C. It has worn valve seals
D. It has a leaking fuel injector - Answer-B. It has a leaking head gasket
An automatic transmission's fluid is pink and milky. Technician A says an overheating
engine causes pink and milky transmission fluid. Technician B says adding too much
transmission fluid to the transmission has caused this condition. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-D. Neither A or B
, Technician A says fuel filters have an arrow that always points toward the fuel tank.
Technician B says a clogged fuel filter reduces fuel pressure at the fuel rail. Who is
correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-B. Technician B
All of the following are true about using a multimeter to test a circuit for continuity
except:
A. Set the multimeter to the Ohms setting
B. Turn the ignition on and power the circuit before testing
C. A reading of OL indicates an open circuit
D. A reading of 0.1 Ohms indicates continuity - Answer-B. Turn the ignition on and
power the circuit before testing
Which of the following is true about the tire in the illustration?
A. It is under-inflated
B. It is over-inflated
C. There is too much camber
D. The coil spring on that wheel is worn - Answer-B. It is over-inflated
An engine is slow cranking. Technician A says there may be resistance in the starter
circuit. Technician B says to perform a voltage drop test to find resistance in a starter
circuit. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-C. Both A and B
Technician A says the illustration above contains two jounce bumpers and two dust
shields. Technician B says jounce bumpers and bump stops protect suspension
components from metal to metal contact. Who is correct?
A. Technician A
B. Technician B
C. Both A and B
D. Neither A or B - Answer-C. Both A and B
A technician is unable to balance a tire on a vehicle that vibrates at speeds above 35
mph. Technician A says to continue adding weights around the rim up to 10 ounces.
