Low pressure boiler black seal Ques ons and answers
Newest RATED A+ 2025/2026 NEW!!
Where on the Cer ficate of Inspec on would you find the State of New Jersey jurisdic on
number? - Answers upper le! corner
Which of the following best describes the combus on chamber of a serpen ne tube hea ng
boiler? - Answers it is located below the tubes
By N.J.A.C. rules, a school with a boiler plant with a total interconnected capacity of 100 BHP
would require a properly licensed operator to be present whenever the building was deemed
occupied. - Answers false
Which of the following is not a classifica on of a hot water system? - Answers a Har,ord loop
system
When bringing a steam hea ng plant on line from a cold start, when the ambient condi ons
are about 20 degrees F, what condi on are you preven ng when the pressure is increased
gradually? - Answers thermal shock
A boiler operator's log shall be maintained in each plant containing over: - Answers 100
Boiler HP
By defini on, a boiler is an open vessel in which water is turned to steam under pressure by the
applica on of heat. - Answers false
According to state boiler regula ons, where should the boiler registra on number be located? -
Answers on the front of the boiler
, As an operator in a plant you must always be aware of your surroundings. Which of the
following, that should be under the control of the licensed operator, can be extremely
dangerous and cause a catastrophic hazardous event if it is not inspected annually? - Answers
The boiler(s) can be dangerous if not inspected and maintained properly
The primary purpose of establishing a set of plant safety rules is to: - Answers protect
workers and equipment
The ASME Code states that the se9ng on the high limit pressure control on a low pressure
steam boiler shall not exceed: - Answers 15 psig
In order to be a good operator one must have basic knowledge on the principles of how energy
works in a steam and hot water system. Which of the statements below is correct? - Answers
in a hea ng system, in order to change state from a liquid to a gaseous state heat must be
added.
What ASME code sec on is used for the care and opera on of hea ng boilers? - Answers
ASME Code, Sec on VI
In a hot water hea ng system, where would you find an expansion tank and what is its
func on? - Answers on the suc on side of the pump to avoid nega ve pressure in the system
What is the official ASME le=er stamp used to denote low pressure hea ng boilers? - Answers
H
What is the maximum penalty for performing the du es of a boiler operator with an expired
license? - Answers $5,000.00
What is the purpose of an aquastat control device on a boiler system? - Answers it is used to
control water temperature
Newest RATED A+ 2025/2026 NEW!!
Where on the Cer ficate of Inspec on would you find the State of New Jersey jurisdic on
number? - Answers upper le! corner
Which of the following best describes the combus on chamber of a serpen ne tube hea ng
boiler? - Answers it is located below the tubes
By N.J.A.C. rules, a school with a boiler plant with a total interconnected capacity of 100 BHP
would require a properly licensed operator to be present whenever the building was deemed
occupied. - Answers false
Which of the following is not a classifica on of a hot water system? - Answers a Har,ord loop
system
When bringing a steam hea ng plant on line from a cold start, when the ambient condi ons
are about 20 degrees F, what condi on are you preven ng when the pressure is increased
gradually? - Answers thermal shock
A boiler operator's log shall be maintained in each plant containing over: - Answers 100
Boiler HP
By defini on, a boiler is an open vessel in which water is turned to steam under pressure by the
applica on of heat. - Answers false
According to state boiler regula ons, where should the boiler registra on number be located? -
Answers on the front of the boiler
, As an operator in a plant you must always be aware of your surroundings. Which of the
following, that should be under the control of the licensed operator, can be extremely
dangerous and cause a catastrophic hazardous event if it is not inspected annually? - Answers
The boiler(s) can be dangerous if not inspected and maintained properly
The primary purpose of establishing a set of plant safety rules is to: - Answers protect
workers and equipment
The ASME Code states that the se9ng on the high limit pressure control on a low pressure
steam boiler shall not exceed: - Answers 15 psig
In order to be a good operator one must have basic knowledge on the principles of how energy
works in a steam and hot water system. Which of the statements below is correct? - Answers
in a hea ng system, in order to change state from a liquid to a gaseous state heat must be
added.
What ASME code sec on is used for the care and opera on of hea ng boilers? - Answers
ASME Code, Sec on VI
In a hot water hea ng system, where would you find an expansion tank and what is its
func on? - Answers on the suc on side of the pump to avoid nega ve pressure in the system
What is the official ASME le=er stamp used to denote low pressure hea ng boilers? - Answers
H
What is the maximum penalty for performing the du es of a boiler operator with an expired
license? - Answers $5,000.00
What is the purpose of an aquastat control device on a boiler system? - Answers it is used to
control water temperature
