Woodworking 1 Final Exam 2026
Questions and Answers
Dado - Correct answer-A cut you make on the table saw that uses several blades
together to make a groove in the board
Relief Cut - Correct answer-A cut you make on the band saw before making long
curved cuts
Irregular - Correct answer-A cut on the band saw that is not straight but is at an
angle and or curved
Kickback - Correct answer-When a board gets stuck between the blade and the
fence and comes back at you
Miter Gauge - Correct answer-Used to cut across the grain of the board
Blind Dado - Correct answer-When you use several blades on the table saw to
make a groove but you do not cut all the way through the board
Rabbet - Correct answer-When you cut a groove at the end of the board
©COPYRIGHT 2025, ALL RIGHTS RESERVE 1
, Compound Miter - Correct answer-Cutting two angles across a board at the same
time
Crosscut - Correct answer-Cutting across the grain of the wood using the miter
gauge
Rip - Correct answer-Cutting with the fence going with the grain of wood
Miter - Correct answer-Cutting at an angle across the board
Fence - Correct answer-Used to cut with the grain of the board
Thickest board you can put through the planer - Correct answer-8 inches
Widest board you can put through the planer - Correct answer-24 inches
Where should you not stand when operating the planer - Correct answer-Behind
the board
Planer: What makes the infeed rollers differemt from the outfeed rollers - Correct
answer-Indeed have grooves
Maximum depth of cut for jointing an edge - Correct answer-1/8 of an inch
Maximum depth of cut for jointing a surface - Correct answer-1/16 of an inch
Shortest board you can put through the jointer - Correct answer-10 inches
©COPYRIGHT 2025, ALL RIGHTS RESERVE 2
Questions and Answers
Dado - Correct answer-A cut you make on the table saw that uses several blades
together to make a groove in the board
Relief Cut - Correct answer-A cut you make on the band saw before making long
curved cuts
Irregular - Correct answer-A cut on the band saw that is not straight but is at an
angle and or curved
Kickback - Correct answer-When a board gets stuck between the blade and the
fence and comes back at you
Miter Gauge - Correct answer-Used to cut across the grain of the board
Blind Dado - Correct answer-When you use several blades on the table saw to
make a groove but you do not cut all the way through the board
Rabbet - Correct answer-When you cut a groove at the end of the board
©COPYRIGHT 2025, ALL RIGHTS RESERVE 1
, Compound Miter - Correct answer-Cutting two angles across a board at the same
time
Crosscut - Correct answer-Cutting across the grain of the wood using the miter
gauge
Rip - Correct answer-Cutting with the fence going with the grain of wood
Miter - Correct answer-Cutting at an angle across the board
Fence - Correct answer-Used to cut with the grain of the board
Thickest board you can put through the planer - Correct answer-8 inches
Widest board you can put through the planer - Correct answer-24 inches
Where should you not stand when operating the planer - Correct answer-Behind
the board
Planer: What makes the infeed rollers differemt from the outfeed rollers - Correct
answer-Indeed have grooves
Maximum depth of cut for jointing an edge - Correct answer-1/8 of an inch
Maximum depth of cut for jointing a surface - Correct answer-1/16 of an inch
Shortest board you can put through the jointer - Correct answer-10 inches
©COPYRIGHT 2025, ALL RIGHTS RESERVE 2
