1|Page
NICET Fire Alarm Level I Actual Exam Preparation
Newest 2025/ 2026 Complete 100 Questions And
Correct Answers With Rationales (Verified
Answers)|Already Graded A+|| Latest Exam!!||
According to NFPA 72, how often shall waterflow devices
be tested? - Answer-Annually
A wall-mounted visible appliance is being installed in a
protected premises that has a height of 6.75 feet. In this
application, what is the maximum distance from the ceiling
that the appliance may be mounted? - Answer-12 inches
For a Class B circuit, where is the end-of-line resistor
located? - Answer-at the device physically farthest from
the panel
Click on the Exhibit button.Which one of the symbols
shown represents a heat detector? - Answer-C
On a peaked ceiling, projected beam-type smoke
detectors must be installed within which maximum
distance from the peak? - Answer-3 feet
,2|Page
Which one of the following is a parallel circuit? - Answer-a
single heat detector
According to OSHA, which electrical cord is safe to use? -
Answer-one that is free of cuts
In a conventional fire alarm system, which component
serves as a contact device that is normally open? -
Answer-high- or low-air pressure switch
Cables installed under a corrugated metal roof deck must
be located at least which minimum distance from the roof
deck? - Answer-1 1/2 inches (1.50)
Fire alarm cable will run exposed inside a building riser.
Which three types of cable are acceptable for this
installation? (Choose three.) - Answer-CMP
Which tool is required for mounting conduit? - Answer-wire
nuts
, 3|Page
According to NFPA 70, a 3/4-inch EMT conduit is
permitted to hold a maximum of how many 14-AWG,
THHN conductors? - Answer-84
Which example describes the correct setup of ladders? -
Answer-ladder is set up 1 foot away per every 4 feet in
height
While standing on the floor, using a battery-operated drill
to cut holes overhead, a technician should wear which two
of the following pieces of safety equipment? (Choose two.)
- Answer-hard hat and safety glasses
What is the difference between a fire alarm control unit
and a fire alarm annunciator? - Answer-The control unit
processes inputs and outputs.
What is the maximum acceptable voltage for NPLFA cable
that is jacketed? - Answer-150 volts
What is the smallest single conductor that is permitted for
use in power limited fire alarm systems? - Answer-18 AWG
NICET Fire Alarm Level I Actual Exam Preparation
Newest 2025/ 2026 Complete 100 Questions And
Correct Answers With Rationales (Verified
Answers)|Already Graded A+|| Latest Exam!!||
According to NFPA 72, how often shall waterflow devices
be tested? - Answer-Annually
A wall-mounted visible appliance is being installed in a
protected premises that has a height of 6.75 feet. In this
application, what is the maximum distance from the ceiling
that the appliance may be mounted? - Answer-12 inches
For a Class B circuit, where is the end-of-line resistor
located? - Answer-at the device physically farthest from
the panel
Click on the Exhibit button.Which one of the symbols
shown represents a heat detector? - Answer-C
On a peaked ceiling, projected beam-type smoke
detectors must be installed within which maximum
distance from the peak? - Answer-3 feet
,2|Page
Which one of the following is a parallel circuit? - Answer-a
single heat detector
According to OSHA, which electrical cord is safe to use? -
Answer-one that is free of cuts
In a conventional fire alarm system, which component
serves as a contact device that is normally open? -
Answer-high- or low-air pressure switch
Cables installed under a corrugated metal roof deck must
be located at least which minimum distance from the roof
deck? - Answer-1 1/2 inches (1.50)
Fire alarm cable will run exposed inside a building riser.
Which three types of cable are acceptable for this
installation? (Choose three.) - Answer-CMP
Which tool is required for mounting conduit? - Answer-wire
nuts
, 3|Page
According to NFPA 70, a 3/4-inch EMT conduit is
permitted to hold a maximum of how many 14-AWG,
THHN conductors? - Answer-84
Which example describes the correct setup of ladders? -
Answer-ladder is set up 1 foot away per every 4 feet in
height
While standing on the floor, using a battery-operated drill
to cut holes overhead, a technician should wear which two
of the following pieces of safety equipment? (Choose two.)
- Answer-hard hat and safety glasses
What is the difference between a fire alarm control unit
and a fire alarm annunciator? - Answer-The control unit
processes inputs and outputs.
What is the maximum acceptable voltage for NPLFA cable
that is jacketed? - Answer-150 volts
What is the smallest single conductor that is permitted for
use in power limited fire alarm systems? - Answer-18 AWG
