Page 1 of 16
Fire Fighter 2 EXAM B 2025 PRACTICE GRADED A+ QUESTIONS WITH CORRECT
ANSWERS 2025-2026 VERIFIED
FireFighter 2
The foam solution is discharged through a ______________ to produce the
finished foam.
foam nozzle
_____________________ add the foam concentrate to the water stream under
pressure. Most injector-based proportioning systems can work across a range
of flow rates and pressures. A metering system measures the flow rate and
pressure of the water and adjusts the injector to add the proper amount of
foam concentrate. This type of system is often installed on special foam
apparatus.
Foam injectors
True or false - The proper nozzle is needed in order for fire fighters to be able
to produce a good-quality foam blanket.
True
The _______________method is used when a pool of flammable product is
located on open ground. The technique is performed by directing the foam
stream onto the ground in front of the product involved. The energy of the
stream will push the foam blanket across the surface of the fuel or roll it onto
the surface of the fuel. The stream is moved back and forth in a slow, steady
horizontal motion to push the foam forward gently until the area is covered.
roll-in
The ____________________ method is used at fires where the fire fighter can
use an object to deflect the foam stream and let it flow down onto the burning
surface. This method could be used to apply foam to an open-top storage tank
or a rolled-over transport vehicle, for example.
bounce-off
The _________________ method is used when there is no object available to
deflect the foam onto the burning surface. This method consists of lofting the
foam stream into the air above the fire and letting it fall down gently onto the
burning surface.
rain-down
When attempting to use foam to extinguish a flammable liquid fire, it is
critically important that enough_______________ is available to complete the
job.
foam concentrate
each length of hose should be tested at least annually, according to the
procedures listed in NFPA _________, Standard for the Care, Use, Inspection,
Service Testing, and Replacement of Fire Hose, Couplings, Nozzles, and Fire
Hose Appliances.
NFPA 1962
Connect up to ____________________ of hose to a hose test gate valve on the
discharge valve of a fire department pumper or hose tester.
300 ft (91 m)
, Page 2 of 16
Slowly fill each hose with water at ________________, and remove kinks and
twists in the hose.
50 psi (345 kPa)
Increase the pressure on the hose to the pressure required by NFPA 1962, and
maintain that pressure for ______minutes.
5
True or False - You must tag hose that failed. the NFPA 1962 test.
True
Each length of hose should be identified with a unique _______________
stenciled or painted on it.
number
All fire suppression operations are either _______________ or
________________
offensive, defensive
Fire fighters should immediately retreat and stay out of the collapse zone if
they notice any of the following signs:
Sudden increase in the intensity of the fire from the roof opening
A _____________________ is performed in two stages, beginning with an
indirect attack and continuing with a direct attack
Combination Attack
____________________appliances may be used to apply thousands of gallons
of water through doors, windows, or holes in the roof
Master Stream
a ______________________is an offensive fire attack method intended to cool
the fire compartment from a safe location prior to making an interior attack.
Transitional Attack
[0.02 m3 ] of liquid propane is converted to _________________of gaseous
propane when it is released into the atmosphere).
270 ft3 [7.64 m3 ]
Inside a propane container, there is a space filled with propane gas
___________ the level of the liquid propane.
Above
The cylinder itself is usually made of _________________. A _______________
valve (or service valve) keeps the gas from escaping into the atmosphere and
controls the flow of gas into the system where it is used.
Steel/Aluminum, Discharge
A propane cylinder is always equipped with a _____________ valve to allow
excess pressure to escape, thereby preventing an explosion if the tank
becomes overheated.
Pressure Relief
Propane (LPG) exists as a gas in its natural state at temperatures higher than
____________.
44°F (-42.2°C)
When responding to a reported LPG leak, fire fighters and their apparatus
should be staged _______________________ of the scene.
uphill and upwind
The greatest danger with propane and similar products is a _______________.
BLEVE
, Page 3 of 16
____________________regulations that have been legally adopted by a
governmental body with the authority to pass laws and enforce safety
regulations— are enacted to ensure a minimum level of fire safety in the home
and workplace environments.
Fire Codes
Fire and building codes are created by the ___________and the
_____________.
NFPA, ICC
Voluntary inspection of a home is called_______________.
Fire Safety Survey
The goals of_______________________, often referred to as public education,
are to help people understand how to prevent the loss of life, injuries, and
property damage from occurring and to teach them how to react in an
appropriate manner if an emergency occurs.
fire and life safety education
The Stop, Drop, and Roll program teaches young children what to do if their
______________catches fire.
Clothing
A second public fire and life safety education
program,___________________________, teaches residents how to safely get
out of their homes in the event of a fire or other emergency.
Exit Drills In The Home (E.D.I.T.H.)
NFPA ______ requires that all smoke alarms be replaced 10 years after the
manufacture date or if they fail the monthly test
NFPA 72
Statistics show that the combination of working smoke alarms and residential
fire sprinklers can reduce the risk of fire death by approximately______(NFPA,
2018).
80%
e. When discussing portable fire extinguishers with the public, it should be
emphasized that they are only recommended for ________ use on small fires.
Adult
Conclude the tour in a _______________. Encourage questions from
participants. Hand out appropriate fire safety materials.
Meeting Room
Make sure that any fire alarm or suppression equipment in the home is
properly
___________________________________________________________________
_.
Installed, maintained, and fully operational
Reference your _____________________before making recommendations on
fire protection equipment.
department's policies
Make sure that the _______________________, is clearly visible from the street
so emergency responders can identify the correct house quickly
house number, or address
Domestic hot water temperatures should not exceed ______________.
120°F (49°C)
Accurate and current information such as drawings, maps, satellite and aerial
imagery, photographs, descriptive text, lists of hazardous materials, and
Fire Fighter 2 EXAM B 2025 PRACTICE GRADED A+ QUESTIONS WITH CORRECT
ANSWERS 2025-2026 VERIFIED
FireFighter 2
The foam solution is discharged through a ______________ to produce the
finished foam.
foam nozzle
_____________________ add the foam concentrate to the water stream under
pressure. Most injector-based proportioning systems can work across a range
of flow rates and pressures. A metering system measures the flow rate and
pressure of the water and adjusts the injector to add the proper amount of
foam concentrate. This type of system is often installed on special foam
apparatus.
Foam injectors
True or false - The proper nozzle is needed in order for fire fighters to be able
to produce a good-quality foam blanket.
True
The _______________method is used when a pool of flammable product is
located on open ground. The technique is performed by directing the foam
stream onto the ground in front of the product involved. The energy of the
stream will push the foam blanket across the surface of the fuel or roll it onto
the surface of the fuel. The stream is moved back and forth in a slow, steady
horizontal motion to push the foam forward gently until the area is covered.
roll-in
The ____________________ method is used at fires where the fire fighter can
use an object to deflect the foam stream and let it flow down onto the burning
surface. This method could be used to apply foam to an open-top storage tank
or a rolled-over transport vehicle, for example.
bounce-off
The _________________ method is used when there is no object available to
deflect the foam onto the burning surface. This method consists of lofting the
foam stream into the air above the fire and letting it fall down gently onto the
burning surface.
rain-down
When attempting to use foam to extinguish a flammable liquid fire, it is
critically important that enough_______________ is available to complete the
job.
foam concentrate
each length of hose should be tested at least annually, according to the
procedures listed in NFPA _________, Standard for the Care, Use, Inspection,
Service Testing, and Replacement of Fire Hose, Couplings, Nozzles, and Fire
Hose Appliances.
NFPA 1962
Connect up to ____________________ of hose to a hose test gate valve on the
discharge valve of a fire department pumper or hose tester.
300 ft (91 m)
, Page 2 of 16
Slowly fill each hose with water at ________________, and remove kinks and
twists in the hose.
50 psi (345 kPa)
Increase the pressure on the hose to the pressure required by NFPA 1962, and
maintain that pressure for ______minutes.
5
True or False - You must tag hose that failed. the NFPA 1962 test.
True
Each length of hose should be identified with a unique _______________
stenciled or painted on it.
number
All fire suppression operations are either _______________ or
________________
offensive, defensive
Fire fighters should immediately retreat and stay out of the collapse zone if
they notice any of the following signs:
Sudden increase in the intensity of the fire from the roof opening
A _____________________ is performed in two stages, beginning with an
indirect attack and continuing with a direct attack
Combination Attack
____________________appliances may be used to apply thousands of gallons
of water through doors, windows, or holes in the roof
Master Stream
a ______________________is an offensive fire attack method intended to cool
the fire compartment from a safe location prior to making an interior attack.
Transitional Attack
[0.02 m3 ] of liquid propane is converted to _________________of gaseous
propane when it is released into the atmosphere).
270 ft3 [7.64 m3 ]
Inside a propane container, there is a space filled with propane gas
___________ the level of the liquid propane.
Above
The cylinder itself is usually made of _________________. A _______________
valve (or service valve) keeps the gas from escaping into the atmosphere and
controls the flow of gas into the system where it is used.
Steel/Aluminum, Discharge
A propane cylinder is always equipped with a _____________ valve to allow
excess pressure to escape, thereby preventing an explosion if the tank
becomes overheated.
Pressure Relief
Propane (LPG) exists as a gas in its natural state at temperatures higher than
____________.
44°F (-42.2°C)
When responding to a reported LPG leak, fire fighters and their apparatus
should be staged _______________________ of the scene.
uphill and upwind
The greatest danger with propane and similar products is a _______________.
BLEVE
, Page 3 of 16
____________________regulations that have been legally adopted by a
governmental body with the authority to pass laws and enforce safety
regulations— are enacted to ensure a minimum level of fire safety in the home
and workplace environments.
Fire Codes
Fire and building codes are created by the ___________and the
_____________.
NFPA, ICC
Voluntary inspection of a home is called_______________.
Fire Safety Survey
The goals of_______________________, often referred to as public education,
are to help people understand how to prevent the loss of life, injuries, and
property damage from occurring and to teach them how to react in an
appropriate manner if an emergency occurs.
fire and life safety education
The Stop, Drop, and Roll program teaches young children what to do if their
______________catches fire.
Clothing
A second public fire and life safety education
program,___________________________, teaches residents how to safely get
out of their homes in the event of a fire or other emergency.
Exit Drills In The Home (E.D.I.T.H.)
NFPA ______ requires that all smoke alarms be replaced 10 years after the
manufacture date or if they fail the monthly test
NFPA 72
Statistics show that the combination of working smoke alarms and residential
fire sprinklers can reduce the risk of fire death by approximately______(NFPA,
2018).
80%
e. When discussing portable fire extinguishers with the public, it should be
emphasized that they are only recommended for ________ use on small fires.
Adult
Conclude the tour in a _______________. Encourage questions from
participants. Hand out appropriate fire safety materials.
Meeting Room
Make sure that any fire alarm or suppression equipment in the home is
properly
___________________________________________________________________
_.
Installed, maintained, and fully operational
Reference your _____________________before making recommendations on
fire protection equipment.
department's policies
Make sure that the _______________________, is clearly visible from the street
so emergency responders can identify the correct house quickly
house number, or address
Domestic hot water temperatures should not exceed ______________.
120°F (49°C)
Accurate and current information such as drawings, maps, satellite and aerial
imagery, photographs, descriptive text, lists of hazardous materials, and
