Written by students who passed Immediately available after payment Read online or as PDF Wrong document? Swap it for free 4.6 TrustPilot
logo-home
Exam (elaborations)

MedGas Exam Questions With 100% Pass

Rating
-
Sold
-
Pages
23
Grade
A+
Uploaded on
25-09-2025
Written in
2025/2026

MedGas Exam Questions With 100% Pass _______ is an inorganic compound, that exist as a gas at atmospheric pressure and temperature, posses a ______ smell. A) Carbon dioxide, burning B) Carbon monoxid, sour C) Nitrous oxide, sweetish D) Methane, bad - Answer- C) Nitrous oxide, sweetish During the outflow test, oxygen and air outlets serving Category 1 spaces shall permit a transient flow rate of _________ SCFM for 3 seconds. A) 8 B) 6 C) 5.0 D) 3.5 - Answer- B) 6 Medical gas risers shall be permitted to be installed in pipe shafts if _______. A) Insulated to protect from freezing B) Installed in schedule 40 PVC sleeve C) Supported at each floor with insulated riser clamps D) Protected from physical damage, excessive heat, or oil - Answer- D) Protected from physical damage, excessive heat, or oil. The ventilation for outdoor locations surrounded by impermeable walls shall have protected ventilation openings located _________ of each wall to allow free circulation of air with in the enclosure. A) at the base B) at the top C) at the upper 1/3 D) in the center - Answer- A) at the base An assembly of equipment such as oxygen storage containers, pressure regulators, pressure relief devices, vaporizers, manifolds, and interconnecting piping that has a storage capacity of more than _________ ft3 is a bulk system. A) 28,000 B) 20,000 C) 10,000 D) 18,000 - Answer- B) 20,000 The three general classes of medical gas piping are ____________. A) main lines, flexible hoses, and equipment drops B) main lines, risers, and branch (lateral) lines C) medical air, medical gas, and medical vacuum D) oxygen, nitrous oxide, and medical air - Answer- B) main lines, risers, and branch (lateral) lines A _______ check fitting shall be provided for all monitors. A) swing B) demand C) gated D) closed - Answer- B) demand A building or portion thereof used to provide services or treatment simultaneously to four or more patients on an outpatient basis, where the patients are incapable of taking action for self-preservation under emergency conditions without the assistance of others is a __________. A) health care facility B) ambulatory health care center C) medical/dental office D) limited care facility - Answer- B) ambulatory health care center Brazed joints shall be continuously purged with oil-free dry nitrogen _________. A) or Argon B) at 15 psi C) until the joint is cool to the touch D) until brazing process is completed - Answer- C) until the joint is cool to the touch A unit of pressure measurement with zero pressure as the base or reference pressure _________. A) SCFM B) PSIG C) PSIA D) ACFM - Answer- C) PSIA Piping systems with the exception of nitrogen systems shall maintain at all station outlets a pressure of _________. A) 45-55 psi B) 40-50 psi C) 50-55 psi D) 60-65 psi - Answer- C) 50-55 psi The Leakage from a completed manufactured assembly shall not exceed __________ of the starting pressure when tested at 20 percent above operating pressure. A) .05 percent B) 5 percent C) 1.5 percent D) .5 percent - Answer- D) .5 percent Instrument air central supply systems shall be equipped with an in-line final particulate/coalescing filtered rated at _______ with filter status indicator. A) 3 micron B) 5 micron C) 0.01 micron D) 1 micron - Answer- C) 0.01 micron A pressure relief valve shall be set at ________. A) 20 percent above and below normal line pressure B) 50 percent above normal line pressure C) 30 to 50 percent above normal line pressure D) 20 percent above normal line pressure - Answer- B) 50 percent above normal line pressure All piping systems shall be subjected to a 24 hours standing test at 20 percent above the normal line pressure. The test gas shall be ______. A) argon B) oil free dry medical air C) oil free dry nitrogen D) medical or laboratory air - Answer- C) oil free dry nitrogen Piping shall be protected against frost, corrosion and _____. A) buried power lines B) physical damage C) heavy traffic D) electrolysis - Answer- B) physical damage The _____ valve shall be located in the immediate vicinity of the source equipment. A) service B) source C) in-line D) main - Answer- B) source Medical air compressors shall be sufficient to serve the peak calculated demand with _____ single compressor out of service. But in no gas shall there be fewer than _____ compressors. A) smallest, 4 B) smallest, 1 C) largest, 2 D) largest, 3 - Answer- C) largest, 2 Cylinders in use and in storage shall be prevented from reaching temperatures in excess of _____. A) 125 F B) 112 F C) 180 F D) 200 F - Answer- A) 125 F The organization, office, or individual responsible for "approving" equipment, an installation or a procedure is _____. A) the local plumbing inspection department B) the state plumbing board C) the uniform plumbing code D) the authority having jurisdiction - Answer- D) the authority having jurisdiction Where on site cleaning is permitted, surfaces shall be cleaned by _____. A) washing and rinsing with tri-chlorothane B) washing in a clean hot solution of trisodium phosphate (1 lb to 3 gal of potable water) C) washing with hot soap water D) washing and carbon tetrachloride - Answer- B) washing in a clean hot solution of trisodium phosphate (1 lb to 3 gal of potable water) The WAGD system that is designed for operation at vacuum less than _____ in HgV is to be used for no other services. A) 12 B) 5 C) 7 D) 9 - Answer- B) 5

Show more Read less
Institution
MedGas
Course
MedGas

Content preview

MedGas Exam Questions With 100%
Pass
_______ is an inorganic compound, that exist as a gas at atmospheric pressure and
temperature, posses a ______ smell.

A) Carbon dioxide, burning
B) Carbon monoxid, sour
C) Nitrous oxide, sweetish
D) Methane, bad - Answer- C) Nitrous oxide, sweetish

During the outflow test, oxygen and air outlets serving Category 1 spaces shall permit a
transient flow rate of _________ SCFM for 3 seconds.

A) 8
B) 6
C) 5.0
D) 3.5 - Answer- B) 6

Medical gas risers shall be permitted to be installed in pipe shafts if _______.

A) Insulated to protect from freezing
B) Installed in schedule 40 PVC sleeve
C) Supported at each floor with insulated riser clamps
D) Protected from physical damage, excessive heat, or oil - Answer- D) Protected from
physical damage, excessive heat, or oil.

The ventilation for outdoor locations surrounded by impermeable walls shall have
protected ventilation openings located _________ of each wall to allow free circulation
of air with in the enclosure.

A) at the base
B) at the top
C) at the upper 1/3
D) in the center - Answer- A) at the base

An assembly of equipment such as oxygen storage containers, pressure regulators,
pressure relief devices, vaporizers, manifolds, and interconnecting piping that has a
storage capacity of more than _________ ft3 is a bulk system.

A) 28,000
B) 20,000
C) 10,000
D) 18,000 - Answer- B) 20,000

,The three general classes of medical gas piping are ____________.

A) main lines, flexible hoses, and equipment drops
B) main lines, risers, and branch (lateral) lines
C) medical air, medical gas, and medical vacuum
D) oxygen, nitrous oxide, and medical air - Answer- B) main lines, risers, and branch
(lateral) lines

A _______ check fitting shall be provided for all monitors.

A) swing
B) demand
C) gated
D) closed - Answer- B) demand

A building or portion thereof used to provide services or treatment simultaneously to
four or more patients on an outpatient basis, where the patients are incapable of taking
action for self-preservation under emergency conditions without the assistance of others
is a __________.

A) health care facility
B) ambulatory health care center
C) medical/dental office
D) limited care facility - Answer- B) ambulatory health care center

Brazed joints shall be continuously purged with oil-free dry nitrogen _________.

A) or Argon
B) at 15 psi
C) until the joint is cool to the touch
D) until brazing process is completed - Answer- C) until the joint is cool to the touch

A unit of pressure measurement with zero pressure as the base or reference pressure
_________.

A) SCFM
B) PSIG
C) PSIA
D) ACFM - Answer- C) PSIA

Piping systems with the exception of nitrogen systems shall maintain at all station
outlets a pressure of _________.

A) 45-55 psi
B) 40-50 psi

, C) 50-55 psi
D) 60-65 psi - Answer- C) 50-55 psi

The Leakage from a completed manufactured assembly shall not exceed __________
of the starting pressure when tested at 20 percent above operating pressure.

A) .05 percent
B) 5 percent
C) 1.5 percent
D) .5 percent - Answer- D) .5 percent

Instrument air central supply systems shall be equipped with an in-line final
particulate/coalescing filtered rated at _______ with filter status indicator.
A) 3 micron
B) 5 micron
C) 0.01 micron
D) 1 micron - Answer- C) 0.01 micron

A pressure relief valve shall be set at ________.

A) 20 percent above and below normal line pressure
B) 50 percent above normal line pressure
C) 30 to 50 percent above normal line pressure
D) 20 percent above normal line pressure - Answer- B) 50 percent above normal line
pressure

All piping systems shall be subjected to a 24 hours standing test at 20 percent above
the normal line pressure. The test gas shall be ______.

A) argon
B) oil free dry medical air
C) oil free dry nitrogen
D) medical or laboratory air - Answer- C) oil free dry nitrogen

Piping shall be protected against frost, corrosion and _____.
A) buried power lines
B) physical damage
C) heavy traffic
D) electrolysis - Answer- B) physical damage

The _____ valve shall be located in the immediate vicinity of the source equipment.

A) service
B) source
C) in-line
D) main - Answer- B) source

Written for

Institution
MedGas
Course
MedGas

Document information

Uploaded on
September 25, 2025
Number of pages
23
Written in
2025/2026
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

$13.99
Get access to the full document:

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Stuviaascorers University of Washington
Follow You need to be logged in order to follow users or courses
Sold
367
Member since
3 year
Number of followers
185
Documents
11068
Last sold
1 week ago
StuviaAscorers | Top Study Notes & Exam Solutions

Stuviaascorers – Your #1 Source for Top-Quality Study Materials! Struggling with exams? Stuviaascorers has got you covered! I provide expertly crafted study notes, summaries, past papers, and exam-ready answers to help you pass with flying colors. My materials are designed for clarity, accuracy, and success—so you can study smarter, not harder! Why Choose My Study Materials? Well-structured & easy to understand – No fluff, just what you need! Exam-focused & high-scoring content – Get straight to the point! Accurate answers & clear explanations – Learn with confidence! Save time & boost your grades – Study efficiently! Don’t leave your success to chance! Browse my documents and start acing your exams today!

Read more Read less
3.8

65 reviews

5
31
4
11
3
11
2
2
1
10

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions