MASTER ELECTRICIAN TEST MONEY MAKER PACKET PREPARATION
NEWEST 2025/2026 COMPLETE QUESTIONS AND CORRECT DETAILED
ANSWERS (VERIFIED ANSWERS) |BRAND NEW VERSION!!
What is the maximum distance from a roof top unit that the roof top GFCI service
receptacle shall be located?
25 ft
A conference room is 250 sq ft and has a 12.5 foot wall. How many floor
receptacles are needed?
2
Does accessory buildings with electrical require illumination under the illuminated
entryway rule?
Yes
General branch circuit lighting load for hospital shall be calculated at __ VA per
square foot?
1
In dwelling units, new additions to heavy duty lamp holders shall be calculated a a
minimum of __VA
600
Where SE cable enters the building, the conduit has to be?
1|Page
, Master Electrician Test Money Maker packet Preparation
Sealed
The conductors for festoon lighting shall be supported by messenger wire in all
spans exceeding?
40ft
What is the minimum service rating for a single-family dwelling with 6 or more 2
wire branch circuits?
100 amps
Circuit breakers used as switches in 120-volt fluorescent lighting shall be marked
as?
SWD and HID
What is the minimum height of a SE conductor going above a pedestrian
sidewalk?
10 ft
Overhead service mast with SE conductors shall be attached between the __ and
the coupling above the buildin
weather head
What is the maximum number of disconnects at the main sergice?
2|Page
, Master Electrician Test Money Maker packet Preparation
6
What is the minimum service disconnect of a commercial building?
60 amps
Cartridge Fuses of any voltage shall provide disconnecting means on their __side
Line
Edison base fuse holders shall be maximum of what voltage?
125 volts
Edison base fuses shall not operate at over?
30 amps
A type S fuse i installed in an Edison base fuse holder for what primary reason?
Non-interchangeable
Cartridge fuses ___ or greater shall have a clearing time of 0.07 seconds or less
1200 amps
SPD line conductors and conductors to ground shall not be smaller than __ copper
#14
For ungrounded surge arresters, the max operating voltage shall be __ of the
system
Phase to phase
3|Page