ATP CTP Course - Final Test 85 Questions with 100%
Correct Answers Updated & Verified
Which of the following statements regarding energy is true? - -d. Kinetic energy can be
traded for potential energy, and potential energy can be traded for kinetic energy
-The objective in maneuvering the airplane is to manage energy so that: - -d. All of the
above
-What is the effect on total drag if airspeed slows below L/D Max? - -c. Drag increases
because of increased induced drag.
-A jet pilot flying at L/D Max will obtain best: - -b. Endurance
-When a jet aircraft is flown at the appropriate airspeed for maximum range, which type of
drag predominates? - -a. Parasite
-While already at high speed, what happens if Mach is allowed to increase? - -d. All of the
above
-What is the result of a shock-induced separation of airflow occurring symmetrically near
the wing root of a swept wing aircraft? - -c. A severe moment of "Mach tuck"
-The speed of sound generally decreases with increasing altitude. This occurs because: - -
a. The air temperature decreases.
-Critical Mach number can be defined as: - -c. The speed of an aircraft in which airflow
over any part of the aircraft or structure first reaches, but doesn't exceed Mach 1.0.
-Stability in the vertical axis tends to drive the sideslip angle toward zero. The most
dynamic stability about the vertical axis on modern jet transports is from: - -c. An active
stability augmentation system / yaw damper.
-Swept wings cause a significant: - -b. Reduction in effectiveness of flaps.
-Why is convergence of Stall AOA and Mmo hazardous? - -d. All of the above
-To maintain altitude in a banked turn, the lift produced by the airplane must be: - -a.
Greater than the airplane weight, and the amount is a function of bank angle.
-Excessive bank angles at high altitudes can be hazardous because: - -d. All of the above
-When operating at constant speed with constant thrust setting at high altitude (typically
above FL250) in slow flight below L/D Max airspeed, any disturbance causing a decrease in
airspeed will result in a further decrease in airspeed unless thrust in increased. High
, altitude recovery from slow flight while turning is best accomplished by: - -c. Increasing
thrust to maximum available thrust and reducing bank angle while accelerating to airspeed
above L/D Max speed. In a thrust limited situation, exiting slow flight will require an
immediate descend as an aerodynamic stall is imminent.
-Maximum Altitude is the highest altitude at which an airplane can be operated. Maximum
Altitude for an airplane is: - -e. The lowest of the above listed altitudes.
-Exceed the critical angle of attack and the surface will stall, and lift will decrease instead
of increasing. This is true: - -d. Regardless of airplane speed or attitude.
-Which of the following statements is true? - -d. Recovery from approach to stall warning
is the same as recovery from a stall.
-The airplane angle of attack is the angle between the wing chord and the oncoming air or
relative wind. - -True
-Airplane stall speeds are published in the Approved Flight Manual for each airplane
model. These speeds are presented as a function of aircraft weight. Therefor if the pilot
maintains airspeed above the appropriate speed listed for the aircraft weight, the aircraft
will not stall. - -False
-The stall speed of an airplane: - -b. Is affected by weight and bank angle.
-Large downward aileron deflections: - -a. Cloud induce air separation over that portion of
the wing at very high angles of attack.
-Place the following steps from the stall recovery template in the correct order: - -d.
Disconnect autopilot and autothrottle / autothurst.
b. Apply nose down pitch control until impeding stall indications are eliminated.
c. Adjust bank angle to wings level.
f. Apply thrust as needed.
a. Retract speed brakes and spoilers.
e. Return to the desire flight path.
-The predominant number of airplane upsets are caused by: - -a. Environmental factors.
-Most of the multi-engine turbojet loss-of-control incidents that are caused by
environmental factors because of: - -d. Wake turbulence
-When initiating recommended airplane upset recovery techniques, the first two
techniques are: - -c. Recognize and confirm the situation and disengage the autopilot and
auto-throtles.
Correct Answers Updated & Verified
Which of the following statements regarding energy is true? - -d. Kinetic energy can be
traded for potential energy, and potential energy can be traded for kinetic energy
-The objective in maneuvering the airplane is to manage energy so that: - -d. All of the
above
-What is the effect on total drag if airspeed slows below L/D Max? - -c. Drag increases
because of increased induced drag.
-A jet pilot flying at L/D Max will obtain best: - -b. Endurance
-When a jet aircraft is flown at the appropriate airspeed for maximum range, which type of
drag predominates? - -a. Parasite
-While already at high speed, what happens if Mach is allowed to increase? - -d. All of the
above
-What is the result of a shock-induced separation of airflow occurring symmetrically near
the wing root of a swept wing aircraft? - -c. A severe moment of "Mach tuck"
-The speed of sound generally decreases with increasing altitude. This occurs because: - -
a. The air temperature decreases.
-Critical Mach number can be defined as: - -c. The speed of an aircraft in which airflow
over any part of the aircraft or structure first reaches, but doesn't exceed Mach 1.0.
-Stability in the vertical axis tends to drive the sideslip angle toward zero. The most
dynamic stability about the vertical axis on modern jet transports is from: - -c. An active
stability augmentation system / yaw damper.
-Swept wings cause a significant: - -b. Reduction in effectiveness of flaps.
-Why is convergence of Stall AOA and Mmo hazardous? - -d. All of the above
-To maintain altitude in a banked turn, the lift produced by the airplane must be: - -a.
Greater than the airplane weight, and the amount is a function of bank angle.
-Excessive bank angles at high altitudes can be hazardous because: - -d. All of the above
-When operating at constant speed with constant thrust setting at high altitude (typically
above FL250) in slow flight below L/D Max airspeed, any disturbance causing a decrease in
airspeed will result in a further decrease in airspeed unless thrust in increased. High
, altitude recovery from slow flight while turning is best accomplished by: - -c. Increasing
thrust to maximum available thrust and reducing bank angle while accelerating to airspeed
above L/D Max speed. In a thrust limited situation, exiting slow flight will require an
immediate descend as an aerodynamic stall is imminent.
-Maximum Altitude is the highest altitude at which an airplane can be operated. Maximum
Altitude for an airplane is: - -e. The lowest of the above listed altitudes.
-Exceed the critical angle of attack and the surface will stall, and lift will decrease instead
of increasing. This is true: - -d. Regardless of airplane speed or attitude.
-Which of the following statements is true? - -d. Recovery from approach to stall warning
is the same as recovery from a stall.
-The airplane angle of attack is the angle between the wing chord and the oncoming air or
relative wind. - -True
-Airplane stall speeds are published in the Approved Flight Manual for each airplane
model. These speeds are presented as a function of aircraft weight. Therefor if the pilot
maintains airspeed above the appropriate speed listed for the aircraft weight, the aircraft
will not stall. - -False
-The stall speed of an airplane: - -b. Is affected by weight and bank angle.
-Large downward aileron deflections: - -a. Cloud induce air separation over that portion of
the wing at very high angles of attack.
-Place the following steps from the stall recovery template in the correct order: - -d.
Disconnect autopilot and autothrottle / autothurst.
b. Apply nose down pitch control until impeding stall indications are eliminated.
c. Adjust bank angle to wings level.
f. Apply thrust as needed.
a. Retract speed brakes and spoilers.
e. Return to the desire flight path.
-The predominant number of airplane upsets are caused by: - -a. Environmental factors.
-Most of the multi-engine turbojet loss-of-control incidents that are caused by
environmental factors because of: - -d. Wake turbulence
-When initiating recommended airplane upset recovery techniques, the first two
techniques are: - -c. Recognize and confirm the situation and disengage the autopilot and
auto-throtles.
