TPC 319 QUESTIONS & ANSWERS
Before new equipment arrives at the plant, plans for installing it are made by the
• Equipment manufacturer
• Maintenance supervisor
• Plant engineer
• Plant superintendent - Answer -• Plant engineer
When pouring a concrete footing, you should hold the steel rods in position with
• metal clips.
• tack welding
• tie wires
• wooden braces - Answer -• tie wires
The type of bolt to anchor the equipment is usually specified by the
• equipment manufacturer
• maintenance department.
• plant engineer
• plot plan - Answer -• equipment manufacturer
To isolate anchor bolts when mounting equipment on pads, surround the bolts with
• coil springs
• neoprene tubing
• plastic sleeves
• steel bushings - Answer -• neoprene tubing
To drill anchor bolt holes larger than 1^1/_2 in., you should use a
• Core bit with a diamond or carbon tip
• high-speed steel drill
• solid carbon-tipped bit
• tool steel drilli - Answer -• Core bit with a diamond or carbon tip
Which of the following should be used to set equipment anchor bolts in an existing
foundation?
• Coarse concrete
• Fine concrete
• Grout
• Mortar - Answer -Grout
Grout must be used within________of mixing
• 15 min
• 1 hr
• 2 hr
• 4 hr - Answer -• 15 min
Before new equipment arrives at the plant, plans for installing it are made by the
• Equipment manufacturer
• Maintenance supervisor
• Plant engineer
• Plant superintendent - Answer -• Plant engineer
When pouring a concrete footing, you should hold the steel rods in position with
• metal clips.
• tack welding
• tie wires
• wooden braces - Answer -• tie wires
The type of bolt to anchor the equipment is usually specified by the
• equipment manufacturer
• maintenance department.
• plant engineer
• plot plan - Answer -• equipment manufacturer
To isolate anchor bolts when mounting equipment on pads, surround the bolts with
• coil springs
• neoprene tubing
• plastic sleeves
• steel bushings - Answer -• neoprene tubing
To drill anchor bolt holes larger than 1^1/_2 in., you should use a
• Core bit with a diamond or carbon tip
• high-speed steel drill
• solid carbon-tipped bit
• tool steel drilli - Answer -• Core bit with a diamond or carbon tip
Which of the following should be used to set equipment anchor bolts in an existing
foundation?
• Coarse concrete
• Fine concrete
• Grout
• Mortar - Answer -Grout
Grout must be used within________of mixing
• 15 min
• 1 hr
• 2 hr
• 4 hr - Answer -• 15 min
