MWS CCRE EXAM ACTUAL 2025/2026 QUESTIONS AND 100% CORRECT ANSWERS

MWS CCRE EXAM ACTUAL 2025/2026 QUESTIONS AND 100% CORRECT ANSWERS The purpose of the priming device test is to: - Answer -Evaluate how quickly the priming device can create a vacuum to bring water through a pumpto the discharge hose. Identify TWO items that should be included on daily MWS apparatus records. - Answer -Coolant levels Traveling at high speeds on a curvy road may cause an MWS apparatus to: - Answer -Leave the road surface and roll over. Identify the THREE steps for changing to the left lane on a limited access highway. - Answer -1. Check the side and rear view mirrors. 2. Activate the turn signal. 3. Move the apparatus safely to the left lane. Identify the FOUR steps for passing through a straight section of a road or highway. - Answer -1. Maintain apparatus speed. 2. Check the side streets or roads. 3. Check the side and rear view mirrors. 4. Check for oncoming traffic.When performing the serpentine exercise, you: - Answer -Should only travel in one direction, without striking the obstruction. All of the following statements about driving an MWS apparatus through areas of restricted horizontal and vertical clearances are true EXCEPT: - Answer -Use the appropriate turn signal. The best type of strainer to use in a shallow stream is a: - Answer - Floating strainer. NFPA rates all fire pumps to meet their capacity from a draft at: - Answer -10 feet of lift. Which equation is used to determine the elevation pressure loss for resupplying a pumper located approximately 20 feet above the location of the MWS? - Answer -EP = 0.5x20 The best definition of water pressure is the: - Answer -Force of water per unit area. All of the following factors must be included when determining the total pressure loss (TPL) EXCEPT: - Answer -Pump pressure loss The hand method can be used for estimating the friction loss in a hoseline with a diameter of: - Answer -2 1/2 inches Large diameter hoses are generally defined as hoses with a diameter between: - Answer -4-6 inches. When a dry supply line is being charged, it is important to open the: - Answer -Bleeder valve. One of the drawbacks of a piston positive displacement pump is the: - Answer -Fire stream tends to pulsate.