Conceptual Actual Frequently Tested Exam
Questions With Reviewed 100% Correct
Detailed Answers
Guaranteed Pass!!Current Update!!
1. What is directly affected by the surface and subsurface conditions of the
building site?
A. Flooring system
B. Foundations
C. Roofing structure
D. Wall framing
2. What term describes the act of removing air pockets from setting concrete?
A. Compaction
B. Vibrating concrete
C. Tamping
D. Screeding
3. Which of the following is not a part of a masonry arch?
A. Radius
B. Keystone
C. Voussoir
D. Spring line
, 4. Anchor bolts should be spaced no more than ___ feet apart, no more than
___ inches from the ends of any plate or corner, and must extend at least
___ inches into concrete.
A. 6 feet, 12 inches, 7 inches
B. 4 feet, 10 inches, 6 inches
C. 8 feet, 8 inches, 8 inches
D. 5 feet, 14 inches, 6 inches
5. In Southern Coastal areas, where should the vapor barrier be placed?
A. On the exterior of the wall
B. On the interior side of the wall
C. Between wall studs
D. Under the insulation
6. When applying gypsum panels to framing, butt joints should be staggered
and located as far from the ___ as possible.
A. Edge
B. Corner
C. Center
D. Ceiling joist
7. What is the minimum temperature that must be maintained during gypsum
board application?
A. 40°F
B. 50°F
C. 55°F
D. 60°F