TPC 319 EXAM QUESTIONS WITH VERIFIED ANSWERS. A+ GRADE 2025/2026.

TPC 319 EXAM QUESTIONS WITH
VERIFIED ANSWERS. A+ GRADE
2025/2026.




Before new equipment arrives at the plant, plans for installing it are made by the
• Equipment manufacturer
• Maintenance supervisor
• Plant engineer

• Plant superintendent - ANS • Plant engineer


When pouring a concrete footing, you should hold the steel rods in position with
• metal clips.
• tack welding
• tie wires

• wooden braces - ANS • tie wires


The type of bolt to anchor the equipment is usually specified by the
• equipment manufacturer
• maintenance department.
• plant engineer

1 @COPYRIGHT 2025/2026 ALLRIGHTS RESERVED

, • plot plan - ANS • equipment manufacturer


To isolate anchor bolts when mounting equipment on pads, surround the bolts with
• coil springs
• neoprene tubing
• plastic sleeves

• steel bushings - ANS • neoprene tubing


To drill anchor bolt holes larger than 1^1/_2 in., you should use a
• Core bit with a diamond or carbon tip
• high-speed steel drill
• solid carbon-tipped bit

• tool steel drilli - ANS • Core bit with a diamond or carbon tip


Which of the following should be used to set equipment anchor bolts in an existing foundation?
• Coarse concrete
• Fine concrete
• Grout

• Mortar - ANS Grout


Grout must be used within________of mixing
• 15 min
• 1 hr
• 2 hr

• 4 hr - ANS • 15 min


To smooth an exposed area of grout, you should
• apply carborundum grit


2 @COPYRIGHT 2025/2026 ALLRIGHTS RESERVED