STEERING AND SUSPENSION TEST(RATED A+)

STEERING AND SUSPENSION
TEST(RATED A+)
Excessive steering wheel play - ANSWERWhich of the following is not a problem
that can be traced to a loose or worn power steering belt?

Camber - ANSWERThe inward or outward tilt of a wheel and tire when viewed from
the front of the car is called __________________.

Ground or floor to a service-manual-specified point on the vehicle. - ANSWER"Curb
height" of a car is the distance from the __________________.

A only - ANSWERTechnician A says "toe in" is produced when the front of the
wheels are closer together than the rear of the wheels. Technician B say "toe in" is
produced when the front of the wheels are farther apart than the rear of the wheels.
Who is right?

Steering shaft - ANSWERComponent that transfers turning motion from steering
wheel to steering gearbox.

Steering gearbox - ANSWERChanges turning motion into straight -line motion.

Steering wheel - ANSWERDevice used by driver to rotate steering shaft.

Ball sockets - ANSWERAllow linkage arms to swivel in all directions for suspension
and steering.



Sway bar - ANSWERTo keep the car body from rolling or leaning excessively in
turns or corners, a __________________ is used.

Runout - ANSWERWhich of the following in not a fundamental angle for proper
wheel alignment?

Track rod - ANSWERA suspension system element sometimes used to prevent side-
to-side axle movement when cornering is called a (n)
__________________________.

Idler arm - ANSWERWhich component can wear enough to allow front wheels to
turn without causing steering wheel movement?

Steering knuckle - ANSWERProvides spindle or bearing support for mounting wheel
hub and wheel assembly.

Spring - ANSWERDevice that supports vehicle weight and permits vertical
movement.