ASE G1 D. SUSPENSION AND STEERING CORRECT 100%

ASE G1 D. SUSPENSION AND
STEERING CORRECT 100%
What is the first step in working with the power steering system? - ANSWERDisarm
airbag (SRS) system.

What should be checked before adjusting the power steering fluid level? -
ANSWERFluid type.

What should be inspected and replaced in the power steering system? -
ANSWERHoses, fittings, O-rings, coolers, and filters.

What should be done before flushing the power steering system? -
ANSWERRetrieve and record diagnostic trouble codes (DTCs).

What should be inspected and replaced in the steering linkage? - ANSWERPitman
arm, center link, idler arm(s), tie rods, tie rod sleeves/adjusters, clamps, and tie rod
ends.

What should be done before inspecting the front suspension system? -
ANSWERDisable air suspension system.

What should be inspected in the front suspension system? - ANSWERUpper and
lower control arms, bushings, shafts, track bar, strut rods/radius arms, upper and
lower ball joints, non-independent front axle assembly, front steering knuckle/spindle
assemblies, and suspension system coil/air springs.

What should be inspected in the front suspension system? - ANSWERLeaf spring(s),
leaf spring insulators (silencers), shackles, brackets, bushings, center pins/bolts,
mounts, torsion bars, stabilizer bar (sway bar) bushings, brackets, links, strut
cartridge/assembly, strut bearing, and mount.

What are the steps to rotate tires/wheels and torque fasteners/wheel locks? -
ANSWERRotate and torque as needed.

What are the steps to dismount and mount tire on wheel? - ANSWERDismount and
mount tire.

What are the steps to balance wheel and tire assembly? - ANSWERBalance wheel
and tire.

What are the steps to identify and test tire pressure monitoring systems (TPMS)? -
ANSWERVerify operation and conduct relearn procedure.

What are the standards to repair tire? - ANSWERRepair according to tire
manufacturers' standards.