1|Page
Bareboat Coastal 103 Newest 2025-2026 Exam
Complete 100 Questions And 100% Correct Detailed
Answers (Verified And Graded A+)
One way twist in the jib can be adjusted is with the
position of the jibsheet car. If the jib has too much twist,
move the car_____. If it needs more twist, move the
car_____ - ANSWER-forward. aft
When reefing the mainsail while underway, it is better to
keep the boat moving on a _____ point of sail - ANSWER-
close reach
When reefing the mainsail, once the new__1___ is
established, take up the__2__ again until the luff is tight,
then establish the new__3__
,2|Page
a) halyard b)tack c)clew - ANSWER-1=tack 2=halyard
3=clew
It is easier to reef or furl the roller-furling job while on
a_____ _____ point of sail. - ANSWER-broad reach
Once the jib is reefed, the jibsheet car (if equipped) should
be moved_____ to maintain balanced tension in the leech
and foot - ANSWER-forward
When heaving-to, the back-winded __1__ and the
leeward-positioned __2__ are in opposition, causing the
boat to sail very slowly with the wind just forward of the
, 3|Page
__3__. When a sailboat with wheel steering is hove-to, the
wheel would be turned fully to __4__
a) Mainsail b)Windward c)Jib d)beam - ANSWER-1=jib
2=mainsail 3=beam 4=b
A vessel is considered overtaking another if it approaches
within an arc of 22.5 degrees abaft the_____ on either
side of the vessel being overtaken.
This total arc of 135 degrees fills the same sector as the
____ light - ANSWER-beam. stern
Bareboat Coastal 103 Newest 2025-2026 Exam
Complete 100 Questions And 100% Correct Detailed
Answers (Verified And Graded A+)
One way twist in the jib can be adjusted is with the
position of the jibsheet car. If the jib has too much twist,
move the car_____. If it needs more twist, move the
car_____ - ANSWER-forward. aft
When reefing the mainsail while underway, it is better to
keep the boat moving on a _____ point of sail - ANSWER-
close reach
When reefing the mainsail, once the new__1___ is
established, take up the__2__ again until the luff is tight,
then establish the new__3__
,2|Page
a) halyard b)tack c)clew - ANSWER-1=tack 2=halyard
3=clew
It is easier to reef or furl the roller-furling job while on
a_____ _____ point of sail. - ANSWER-broad reach
Once the jib is reefed, the jibsheet car (if equipped) should
be moved_____ to maintain balanced tension in the leech
and foot - ANSWER-forward
When heaving-to, the back-winded __1__ and the
leeward-positioned __2__ are in opposition, causing the
boat to sail very slowly with the wind just forward of the
, 3|Page
__3__. When a sailboat with wheel steering is hove-to, the
wheel would be turned fully to __4__
a) Mainsail b)Windward c)Jib d)beam - ANSWER-1=jib
2=mainsail 3=beam 4=b
A vessel is considered overtaking another if it approaches
within an arc of 22.5 degrees abaft the_____ on either
side of the vessel being overtaken.
This total arc of 135 degrees fills the same sector as the
____ light - ANSWER-beam. stern
