Florida Class C Water Treatment Operator Exam
2025 Prep Test Bank with 600 Most Recent
Questions and Correct Verified Answers/ FL Class C
Water Operator Test Latest (Brand New!)
The Activated Sludge Process:
A. requires preaeration
B. requires Activated Carbon
C. is an aerobic biological process.
D. Usually precedes primary sedimentation.
E. Requires 50% by volume old sludge to work effectively.
- ...ANSWER...✓✓ C. Is an Aerobic biological process
A complete mix activated sludge plant has a fast settling
sludge and high amounts of pin floc leaving the clarifier.
One way to correct this problem is to :
A. Increase the RAS Flow
B. Reduce Wasting Rates
C. Increase dissolved oxygen levels.
D. Increase the F/M ratio by wasting more
,2|Page
E. Increase the sludge age by wasting less. -
...ANSWER...✓✓ D. Increase the F/M Ratio by Wasting
More
Which of the following flow rates should be measured if
the operator is to control plant properly?
A. Aeration rate or resulting dissolved oxygen level.
B. Influent or effluent.
C. return sludge
D. waste sludge
E. all the above - ...ANSWER...✓✓ E. all the above
During start up your aeration tank produces excessive
amounts of billowing white foam. This can be corrected
by:
A. Doing nothing, it will go away in a few hours
B. Increasing the sludge wasting rate
C. Seeding the process with sufficient good quality sludge
D. Spraying water on the foam until it is gone
, 3|Page
E. Taking a weeks vacation - ...ANSWER...✓✓ C. Seeding
the process with sufficient good quality sludge
In solving an operational problem at a treatment plant:
A. there is almost always a good technical solution. It may
require considerable experience and time to learn whaat
it is.
B. Human errors have to be corrected since the operator
is at fault.
C. don't let the laboratory personnel influence you're
judgement as to what the best solution is.
D. standard textbooks in sanitary engineering are the best
source of information.
E. It is best to do nothing until the TNRCCC sends a
violation notice. - ...ANSWER...✓✓ A. there is almost
always a good technical solution. It may require
considerable experience and time to learn whaat it is.
When the return sludge rate is too low, what happens?
A. the aeration tank will not fill