Page |1
FDNY P-99 C OF F EXAM 2025|BRAND NEW
ACTUAL EXAM WITH 100% VERIFIED
QUESTIONS AND CORRECT
ANSWERS|EXCELLENT SCORES
What is a general requirement of the location of the installation of a boiler? -
correct-answer-Adequate clearance from combustile construction
What temperature must the materials remain under during combustion? -
correct-answer-170 degrees
What is a requirement for the access of the boiler? - correct-answer-Access for
operation and maintenance must not be hazardous
Where should a relief valve be installed? - correct-answer-In the discharge line
between the pump and the first shut off valve
How is oil heated in storage tanks? - correct-answer-Coils using low pressure hot
water/steam or approved electric heaters.
, Page |2
Where are shut off valves required? - correct-answer-One at the supply line at the
tank and and one at the supply line at the burner
What stops the flow of oil? - correct-answer-Remote control
Where is the remote control located? - correct-answer-As close to the entrance of
the boiler room as practical or immediately inside as long as it's accessible at all
times. On tank if 60 gal or less
What are the 4 safety controls implemented? - correct-answer-Oil temperature
control, ignition, stack/combustion control, and high pressure and temperature
control.
Is a chimney required to install a burner? - correct-answer-Yes
What temperature is no. 6 oil heated to in the tank? - correct-answer-100-130
degrees
FDNY P-99 C OF F EXAM 2025|BRAND NEW
ACTUAL EXAM WITH 100% VERIFIED
QUESTIONS AND CORRECT
ANSWERS|EXCELLENT SCORES
What is a general requirement of the location of the installation of a boiler? -
correct-answer-Adequate clearance from combustile construction
What temperature must the materials remain under during combustion? -
correct-answer-170 degrees
What is a requirement for the access of the boiler? - correct-answer-Access for
operation and maintenance must not be hazardous
Where should a relief valve be installed? - correct-answer-In the discharge line
between the pump and the first shut off valve
How is oil heated in storage tanks? - correct-answer-Coils using low pressure hot
water/steam or approved electric heaters.
, Page |2
Where are shut off valves required? - correct-answer-One at the supply line at the
tank and and one at the supply line at the burner
What stops the flow of oil? - correct-answer-Remote control
Where is the remote control located? - correct-answer-As close to the entrance of
the boiler room as practical or immediately inside as long as it's accessible at all
times. On tank if 60 gal or less
What are the 4 safety controls implemented? - correct-answer-Oil temperature
control, ignition, stack/combustion control, and high pressure and temperature
control.
Is a chimney required to install a burner? - correct-answer-Yes
What temperature is no. 6 oil heated to in the tank? - correct-answer-100-130
degrees
