ICC VAPOR RECOVERY 1 CHEMICAL ENGINEERING COURSE
2025/2026 | VERIFIED QUESTIONS AND ANSWERS GRADED A+ |
VAPOR RECOVERY SYSTEMS, CHEMICAL PROCESSES & SAFETY
STUDY GUIDE | GUARANTEED SUCCESS
One of the approved methods of overfill prevention is to have an overfill device
that will automatically shut off fill into the tank when the tank is a maximum of
____ % full.
A. 80
B. 90
C. 95
D. 75 - CORRECT ANSWER - C. 95
In the PEI #300 manual, pressure decay, dynamic back pressure, and A/L
testing satisfy who's testing requirements?
A. CARB
B. water resources
C. environmental health
D. fire department - CORRECT ANSWER - A. CARB
When removing liquid from a sump or spill bucket and the liquid contains fuel,
it must ____?
A. be managed as hazardous waste
B. pumped into a bucket to evaporate
C. scooped or bailed onto the concrete pad to evaporate
,D. put into a sealed container, then put into the trash container - CORRECT
ANSWER - A. be managed as hazardous waste
Before working on any electrical circuits always de-energize and use
A. NFPA
B. OSHA
C. ICC
D. UBC - CORRECT ANSWER - A. NFPA
The two point Phase I vapor recovery system requires that a separate vapor
recovery riser pipe be installed in the tank and be equipped with a ____?
A. drop-tube
B. locking block valve
C. P/V vent
D. vapor recovery adaptor - CORRECT ANSWER - D. vapor recovery
adaptor
The term "hanging hardware" refers to...
A. nozzle, hose breakaway
B. vent cap, nozzle, swivel
C. shear valve, UDC, hose
D. sump sensor, vapor valve, nozzle - CORRECT ANSWER - A. nozzle, hose
breakaway
, A valve installed in a motor-vehicle fueling hose designed to separate with little
or no product spillage when excessive pulling force is placed on the hose is
called ____?
A. breakaway
B. hose clamp
C. shear valve
D. flow limiter - CORRECT ANSWER - A. breakaway
In the PEI #500 manual, a Level II Qualified Person can do all EXCEPT:
a. open cabinet doors
b. reconnect breakaways
c. measure nozzle flow rates
d. repair or replace dispenser components - CORRECT ANSWER - d. repair
or replace dispenser components
Which of the following is not considered "hanging hardware"?
a. nozzle
b. swivel
c. whip hose
d. shear valve - CORRECT ANSWER - d. shear valve
Per Executive Order. VR-201-E, if the dispensing vacuum of the Healy VP-
1000 pump is below ____ inches of WC, the dispenser should be removed from
service.
A. 50
B. 60
2025/2026 | VERIFIED QUESTIONS AND ANSWERS GRADED A+ |
VAPOR RECOVERY SYSTEMS, CHEMICAL PROCESSES & SAFETY
STUDY GUIDE | GUARANTEED SUCCESS
One of the approved methods of overfill prevention is to have an overfill device
that will automatically shut off fill into the tank when the tank is a maximum of
____ % full.
A. 80
B. 90
C. 95
D. 75 - CORRECT ANSWER - C. 95
In the PEI #300 manual, pressure decay, dynamic back pressure, and A/L
testing satisfy who's testing requirements?
A. CARB
B. water resources
C. environmental health
D. fire department - CORRECT ANSWER - A. CARB
When removing liquid from a sump or spill bucket and the liquid contains fuel,
it must ____?
A. be managed as hazardous waste
B. pumped into a bucket to evaporate
C. scooped or bailed onto the concrete pad to evaporate
,D. put into a sealed container, then put into the trash container - CORRECT
ANSWER - A. be managed as hazardous waste
Before working on any electrical circuits always de-energize and use
A. NFPA
B. OSHA
C. ICC
D. UBC - CORRECT ANSWER - A. NFPA
The two point Phase I vapor recovery system requires that a separate vapor
recovery riser pipe be installed in the tank and be equipped with a ____?
A. drop-tube
B. locking block valve
C. P/V vent
D. vapor recovery adaptor - CORRECT ANSWER - D. vapor recovery
adaptor
The term "hanging hardware" refers to...
A. nozzle, hose breakaway
B. vent cap, nozzle, swivel
C. shear valve, UDC, hose
D. sump sensor, vapor valve, nozzle - CORRECT ANSWER - A. nozzle, hose
breakaway
, A valve installed in a motor-vehicle fueling hose designed to separate with little
or no product spillage when excessive pulling force is placed on the hose is
called ____?
A. breakaway
B. hose clamp
C. shear valve
D. flow limiter - CORRECT ANSWER - A. breakaway
In the PEI #500 manual, a Level II Qualified Person can do all EXCEPT:
a. open cabinet doors
b. reconnect breakaways
c. measure nozzle flow rates
d. repair or replace dispenser components - CORRECT ANSWER - d. repair
or replace dispenser components
Which of the following is not considered "hanging hardware"?
a. nozzle
b. swivel
c. whip hose
d. shear valve - CORRECT ANSWER - d. shear valve
Per Executive Order. VR-201-E, if the dispensing vacuum of the Healy VP-
1000 pump is below ____ inches of WC, the dispenser should be removed from
service.
A. 50
B. 60
