ICC VAPOR RECOVERY 1 LATEST EXAM
2026/2027 WITH ORGANIZED
QUESTIONS FULLY SOLVED EXPERT
VERIFIED STEP BY STEP
EXPLANATIONS AND REVIEW GUIDE
GRADED A+ AND 100% PASSS
GUARANTEE (ORIGINAL COPY!!!!!!
Which of the following is not an overfill device?
A. ball-float
B. spill-bucket
C. tank overfill alarm
D. drop-tube flapper valve - THE CORRECT ANSWER-B. spill-bucket
Piping should have a minimum and maximum slope of ____
inch
A. 1/16"-1/8"
B. 1/8"-1/4"
C. 1/8"-3/16"
D. 1/4"-1/2" - THE CORRECT ANSWER-B. 1/8"-1/4"
,What is the appropriate way to clean up a small spill of
gasoline?
A. allow the product to evaporate from the area
B. wash the spilled product from the area with water
C. apply absorbent to the affected area and leave to soak up fuel
D. apply absorbent to the affected area, then remove & dispose
of absorbent in accordance with applicable requirements - THE
CORRECT ANSWER-D. apply absorbent to the affected area, then
remove & dispose of absorbent in accordance with applicable
requirements
Placing a bare copper wire from the ____ to the ____ with it's
ends exposed is helpful with pipe run locating.
A. tank monitor to emergency shut-off switch
B. tank to turbine
C. vapor recovery bucket to interstitial monitor
D. dispenser pipe run to the tank turbine - THE CORRECT ANSWER-D.
dispenser pipe run to the tank turbine
One of the approved methods of overfill prevention is to have
an overfill device that will automatically shut off fill into the
tank when the tank is a maximum of ____ % full.
A. 80
B. 90
C. 95
, D. 75 - THE CORRECT ANSWER-C. 95
In the PEI #300 manual, pressure decay, dynamic back
pressure, and A/L testing satisfy who's testing requirements?
A. CARB
B. water resources
C. environmental health
D. fire department - THE CORRECT ANSWER-A. CARB
When removing liquid from a sump or spill bucket and the
liquid contains fuel, it must ____?
A. be managed as hazardous waste
B. pumped into a bucket to evaporate
C. scooped or bailed onto the concrete pad to evaporate
D. put into a sealed container, then put into the trash container
- THE CORRECT ANSWER-A. be managed as hazardous waste
Before working on any electrical circuits always de-energize and
use
A. NFPA
B. OSHA
C. ICC
D. UBC - THE CORRECT ANSWER-A. NFPA
2026/2027 WITH ORGANIZED
QUESTIONS FULLY SOLVED EXPERT
VERIFIED STEP BY STEP
EXPLANATIONS AND REVIEW GUIDE
GRADED A+ AND 100% PASSS
GUARANTEE (ORIGINAL COPY!!!!!!
Which of the following is not an overfill device?
A. ball-float
B. spill-bucket
C. tank overfill alarm
D. drop-tube flapper valve - THE CORRECT ANSWER-B. spill-bucket
Piping should have a minimum and maximum slope of ____
inch
A. 1/16"-1/8"
B. 1/8"-1/4"
C. 1/8"-3/16"
D. 1/4"-1/2" - THE CORRECT ANSWER-B. 1/8"-1/4"
,What is the appropriate way to clean up a small spill of
gasoline?
A. allow the product to evaporate from the area
B. wash the spilled product from the area with water
C. apply absorbent to the affected area and leave to soak up fuel
D. apply absorbent to the affected area, then remove & dispose
of absorbent in accordance with applicable requirements - THE
CORRECT ANSWER-D. apply absorbent to the affected area, then
remove & dispose of absorbent in accordance with applicable
requirements
Placing a bare copper wire from the ____ to the ____ with it's
ends exposed is helpful with pipe run locating.
A. tank monitor to emergency shut-off switch
B. tank to turbine
C. vapor recovery bucket to interstitial monitor
D. dispenser pipe run to the tank turbine - THE CORRECT ANSWER-D.
dispenser pipe run to the tank turbine
One of the approved methods of overfill prevention is to have
an overfill device that will automatically shut off fill into the
tank when the tank is a maximum of ____ % full.
A. 80
B. 90
C. 95
, D. 75 - THE CORRECT ANSWER-C. 95
In the PEI #300 manual, pressure decay, dynamic back
pressure, and A/L testing satisfy who's testing requirements?
A. CARB
B. water resources
C. environmental health
D. fire department - THE CORRECT ANSWER-A. CARB
When removing liquid from a sump or spill bucket and the
liquid contains fuel, it must ____?
A. be managed as hazardous waste
B. pumped into a bucket to evaporate
C. scooped or bailed onto the concrete pad to evaporate
D. put into a sealed container, then put into the trash container
- THE CORRECT ANSWER-A. be managed as hazardous waste
Before working on any electrical circuits always de-energize and
use
A. NFPA
B. OSHA
C. ICC
D. UBC - THE CORRECT ANSWER-A. NFPA
