} Practice Questions and
Verified Answers {Grade A} 100 % Correct
A vehicle is undergoing a Smog check inspection. The under-hood BAR referee
emissions label lists an ECS that is not in the vehicle. How should the technician
handle this situation - correct answer List the system as missing in the EIS machine
A smog technician has scanned the DMV registration document. The VIN number of
the vehicle does not match the VIN number on the DMV paperwork. What must the
technician do? - correct answer Run the smog check using the VIN number on the
vehicle and note the VIN discrepancy on the paper work.
A 2001MY vehicle comes in for a smog inspection. Upon visual inspection the
inspector notices that the vehicle is equipped with a biodiesel kit. Technician A states
that the inspector must check the part for an ARB EO exemption. Technician B states
EO exemptions for biodiesel kits only apply to vehicles 2004MY and newer Who is
Correct? - correct answer Technician B
The Three-Way Catalytic Converter Helped reduce what emission not previously
controlled by the oxidizing converter - correct answer NOx
A Customer whose vehicle has failed the Smog Check inspection has been approved
for a repair cost waiver. How long is the duration of the repair cost waiver? - correct
answer Two years or 2 years
, Smog Inspector BAR EXAM {Latest Update
} Practice Questions and
Verified Answers {Grade A} 100 % Correct
Technician A says that all vehicles with fuel evaporation from 1976 to 1995 are subject
to the LPFET functional test. Technician B says that only vehicles older than 1996
receiving a TSI test are subject to the functional EGR test. Who's correct? - correct
answer Both Technicians
The OBD II functional test evaluates and reports the status of all the following,
except? - correct answer Mode 6 Pending Codes
While conducting a functional test on an EGR valve, the technician increases RPM and
can see the valve Pinole move up. Based on that information, how would the
technician enter this condition into the emission inspection system (EIS)?
Pass
N/A
Defective
None of the above - correct answer NONE OF THE ABOVE
Two technicians are discussing the procedures for performing the ignition timing
functional test. Technician A states that if no manufacturer engine speed tolerance is
given, the idle speed should be within 100 RPM of manufacturers specified idle speed.
Technician B states that if the procedures for timing check are nit found in the under