NCCCO TSS MANITEX EXAM STUDY
GUIDE 2026 COMPLETE QUESTIONS
WITH CORRECT DETAILED ANSWERS
|| 100% GUARANTEED PASS
<LATEST VERSION>
1. Which of the following is an accurate statement about luffing jibs? -
ANSWER ✔ It raises and lowers independent from the boom
2. What is the weakest quadrant of a boom truck? - ANSWER ✔ Front
3. What effect would blocking up the ends of the tracks have on a crane? -
ANSWER ✔ It would increase capacity over the ends
4. The tipping axis of a crawler crane is? - ANSWER ✔ It depends if the idler
or sprocket are offset from track rollers
5. According to ASME B30.5 what percentage should not be exceeded on a
mobile crane during a load test? - ANSWER ✔ 100%
6. From strongest to weakest put the following hitches in order - ANSWER ✔
Basket, vertical, choker
,7. Which of the following should synthetic slings not be used around? -
ANSWER ✔ Acid
8. How often should you inspect a running rope? - ANSWER ✔ Daily
9. The radius on a crane chart refers to? - ANSWER ✔ Center of rotation to
center of gravity of the load or hook
10.What percentage is the manufacture rate of capacity of a mobile crane on
outriggers? - ANSWER ✔ 85%
11.What percentage is the manufacture rated capacity of a rough terrain crane
on rubber? - ANSWER ✔ 75%
12.What would call for a rotation resistant rope to be taken out of service? -
ANSWER ✔ 2 Broken wires and 6 rope diameters
13.OSHA requires a distance be maintained from powerline when the voltage is
unknown but under 350 KV - ANSWER ✔ 20 ft
14.What is minimum distance for a crane operations around powerlines up to
50 KV? - ANSWER ✔ 20ft
15.What is minimum distance for a crane operations around powerlines up to
50 KV? - ANSWER ✔ 6 ft
, 16.The site supervisor and the lift Director can be the same person? - ANSWER
✔ True
17.No lift must be made on the cranes other hoist when hoisted personnel -
ANSWER ✔ True
18.If the cranes operator does not recognize the signal, the operator should -
ANSWER ✔ Stop
19.When lifting a load over the side, the crane operator should use the_______
Chart - ANSWER ✔ 360 degrees chart
20.If using a 1 inch wire rope sling to basket around a 4 inch pipe. What is the
DD ratio used for determine how much capacity can be lost - ANSWER ✔
4/1
21.What is the minimum distance for a crane operations around the powerline
up to 50 KV? - ANSWER ✔ 10 ft
22.What is the minimum distance around powerlines with the boom and transit
position while driving under powerlines? - ANSWER ✔ 4 ft
23.What is the minimum distance for a crane operations around powerlines that
are 720 KV? - ANSWER ✔ 35 ft
24.What is the minimum distance around powerlines with boom in transit
position while driving under power lines and voltage is 350 KV - ANSWER
✔ 16 ft
GUIDE 2026 COMPLETE QUESTIONS
WITH CORRECT DETAILED ANSWERS
|| 100% GUARANTEED PASS
<LATEST VERSION>
1. Which of the following is an accurate statement about luffing jibs? -
ANSWER ✔ It raises and lowers independent from the boom
2. What is the weakest quadrant of a boom truck? - ANSWER ✔ Front
3. What effect would blocking up the ends of the tracks have on a crane? -
ANSWER ✔ It would increase capacity over the ends
4. The tipping axis of a crawler crane is? - ANSWER ✔ It depends if the idler
or sprocket are offset from track rollers
5. According to ASME B30.5 what percentage should not be exceeded on a
mobile crane during a load test? - ANSWER ✔ 100%
6. From strongest to weakest put the following hitches in order - ANSWER ✔
Basket, vertical, choker
,7. Which of the following should synthetic slings not be used around? -
ANSWER ✔ Acid
8. How often should you inspect a running rope? - ANSWER ✔ Daily
9. The radius on a crane chart refers to? - ANSWER ✔ Center of rotation to
center of gravity of the load or hook
10.What percentage is the manufacture rate of capacity of a mobile crane on
outriggers? - ANSWER ✔ 85%
11.What percentage is the manufacture rated capacity of a rough terrain crane
on rubber? - ANSWER ✔ 75%
12.What would call for a rotation resistant rope to be taken out of service? -
ANSWER ✔ 2 Broken wires and 6 rope diameters
13.OSHA requires a distance be maintained from powerline when the voltage is
unknown but under 350 KV - ANSWER ✔ 20 ft
14.What is minimum distance for a crane operations around powerlines up to
50 KV? - ANSWER ✔ 20ft
15.What is minimum distance for a crane operations around powerlines up to
50 KV? - ANSWER ✔ 6 ft
, 16.The site supervisor and the lift Director can be the same person? - ANSWER
✔ True
17.No lift must be made on the cranes other hoist when hoisted personnel -
ANSWER ✔ True
18.If the cranes operator does not recognize the signal, the operator should -
ANSWER ✔ Stop
19.When lifting a load over the side, the crane operator should use the_______
Chart - ANSWER ✔ 360 degrees chart
20.If using a 1 inch wire rope sling to basket around a 4 inch pipe. What is the
DD ratio used for determine how much capacity can be lost - ANSWER ✔
4/1
21.What is the minimum distance for a crane operations around the powerline
up to 50 KV? - ANSWER ✔ 10 ft
22.What is the minimum distance around powerlines with the boom and transit
position while driving under powerlines? - ANSWER ✔ 4 ft
23.What is the minimum distance for a crane operations around powerlines that
are 720 KV? - ANSWER ✔ 35 ft
24.What is the minimum distance around powerlines with boom in transit
position while driving under power lines and voltage is 350 KV - ANSWER
✔ 16 ft
