MK1 swe EXAM NEWEST VERSION ALL 450 QUESTIONS AND CORRECT ANSWERS WITH LATEST

Page 1 of 190



MK1 swe EXAM NEWEST VERSION ALL 450 QUESTIONS
AND CORRECT ANSWERS WITH LATEST UPDATE JUST
RELEASED THIS YEAR


Question: A detailed Boat Inspection Report (CG-3022) shall be submitted on _____ - CORRECT

ANSWER✔✔All boats less than 65 feet in length




Question: Group/sector and district commands shall schedule a detailed boat inspection of

each boat at an interval not to exceed _____ - CORRECT ANSWER✔✔1 year between

inspections




Q:A _____ or _____ equivalent shall be submitted for all vessels _____ ft or greater annually

covering a 12 month period ending Dec. 31st. - CORRECT ANSWER✔✔Cutter Engineering Report

(CG 4874), CM+ equivalent, 65




Question: Section VI of the cutter engineering report - CORRECT ANSWER✔✔For general

remarks not covered elsewhere in the report

, Page 2 of 190


Question: Who develops and publishes guidance for the preparation, submittal and processing

of SSMR's - CORRECT ANSWER✔✔MLC's




Question: Casualties affecting a secondary mission shall always have a casualty category of

_____? - CORRECT ANSWER✔✔Category 2




Question: A statement of work specifies in clear understandable terms the work to be done by

a _____? - CORRECT ANSWER✔✔Contractor




Question: A bright spot found on each end of a broken piston ring indicates - CORRECT

ANSWER✔✔Insufficient gap clearance




Question: A _____ is installed on the tank to prevent the pump motor and solenoid valve from

becoming energized in the event the condensate tank water is low - CORRECT ANSWER✔✔Float

switch




Question: The distance the driving bore of a hub is out of parallel with the shaft center line -

CORRECT ANSWER✔✔Bore run out

, Page 3 of 190




Question: Any eccentricity or perpendicularity errors mush be accounted for in _____ -

CORRECT ANSWER✔✔The alignment process




Question: How do you check the bore alignment - CORRECT ANSWER✔✔Take measurements

of the diameter gap at four equally spaced points on the flanges diameter




Question: To check angular alignment - CORRECT ANSWER✔✔Use a feeler gauge at four equal

spaces




Question: Specific authorization from the _____ is required before removal of an inspection

plate, connection, fitting or cover which permits access to the gear casing - CORRECT

ANSWER✔✔Engineering Officer




Question: At the first sign of emulsion _____ and _____ - CORRECT ANSWER✔✔Stop the plant,

change the oil




Question: All cutters 65 feet and longer are required to maintain _____ - CORRECT

ANSWER✔✔A machinery history file

, Page 4 of 190




Question: The amount of deflection of a crankshaft may be determined by the use of _____ -

CORRECT ANSWER✔✔A strain gauge




Question: The _____ reports identifying info for all navy reporting system (NRS) messages.

Signifies beginning of formatted information. Also the message type and message originator -

CORRECT ANSWER✔✔MSGID




Question: The _____ reports a units present location and effective date-time - CORRECT

ANSWER✔✔POSIT




Question: The _____ reports the requirement for outside assistance - CORRECT

ANSWER✔✔ASSIST




Question: SSMR Priority 1 - CORRECT ANSWER✔✔Immediate




Question: SSMR Priority 2 - CORRECT ANSWER✔✔Early accomplishment, 6 months-2 years