MP100-02 Study Guide Questions with Correct Answers
1. This person's job is to interpret and capture the sonic Engineer
and creative vision of the producer, artist, and record
label through a recording and/or mix
2. A time relationship between two or more waveforms Phase
3. The name fro the brain's perception of a physical audi- Subjective Sound
tory stimulus
4. This person's job is to run the tape machine, Pro Tools, Assistant Engineer
setup and tear down sessions, document the session,
and make sure the session runs smoothly
5. Any device that changes one form of energy into an- Transducer
other corresponding form of energy
6. An area that has a greater than normal barometric Compression
pressure
7. An area that has less than normal barometric pressure Rarefaction
8. The person who helps the artist and/or record label Producer
create the best possible recorded performance and
final product, and is also in charge of the entire session
9. The process of sound pressure waves "traveling" Propagation
through the air
10. A graphic representation of a signal's sound pressure Waveform
level or voltage level over time
11. The distance above or below the centerline of a wave- Amplitude
form
1/5
, MP100-02 Study Guide Questions with Correct Answers
12. The actual distance between the beginning and end of Wavelength
a cycle
13. The difference in time between two waveforms Phase Shift
14. The note being played Fundamental
15. Waves that are not necessarily symmetrical and don't Complex Waves
necessarily repeat
16. The unit of measurement for sound pressure level, Decibel, dB
voltage level, etc.
17. A purpose built room designed specifically for critical Control Room
listening
18. Gives the engineer the ability to manipulate the au- Console
dio signals, combine those signals together, and route
those signals throughout the studio
19. Meant to provide acoustic isolation within the studio Isolation Booth
20. Three main steps of the multitrack recording process Recording, Overdubbing,
Mixing
21. Name the three electrical levels Mic, Line, Speaker
(mV, 1.2V, 1-50V)
22. List the seven waveform characteristics Wavelength, Amplitude,
Velocity, Envelope, Phase,
Frequency, Harmonic
Content
23. Peak Amplitude
2/5
1. This person's job is to interpret and capture the sonic Engineer
and creative vision of the producer, artist, and record
label through a recording and/or mix
2. A time relationship between two or more waveforms Phase
3. The name fro the brain's perception of a physical audi- Subjective Sound
tory stimulus
4. This person's job is to run the tape machine, Pro Tools, Assistant Engineer
setup and tear down sessions, document the session,
and make sure the session runs smoothly
5. Any device that changes one form of energy into an- Transducer
other corresponding form of energy
6. An area that has a greater than normal barometric Compression
pressure
7. An area that has less than normal barometric pressure Rarefaction
8. The person who helps the artist and/or record label Producer
create the best possible recorded performance and
final product, and is also in charge of the entire session
9. The process of sound pressure waves "traveling" Propagation
through the air
10. A graphic representation of a signal's sound pressure Waveform
level or voltage level over time
11. The distance above or below the centerline of a wave- Amplitude
form
1/5
, MP100-02 Study Guide Questions with Correct Answers
12. The actual distance between the beginning and end of Wavelength
a cycle
13. The difference in time between two waveforms Phase Shift
14. The note being played Fundamental
15. Waves that are not necessarily symmetrical and don't Complex Waves
necessarily repeat
16. The unit of measurement for sound pressure level, Decibel, dB
voltage level, etc.
17. A purpose built room designed specifically for critical Control Room
listening
18. Gives the engineer the ability to manipulate the au- Console
dio signals, combine those signals together, and route
those signals throughout the studio
19. Meant to provide acoustic isolation within the studio Isolation Booth
20. Three main steps of the multitrack recording process Recording, Overdubbing,
Mixing
21. Name the three electrical levels Mic, Line, Speaker
(mV, 1.2V, 1-50V)
22. List the seven waveform characteristics Wavelength, Amplitude,
Velocity, Envelope, Phase,
Frequency, Harmonic
Content
23. Peak Amplitude
2/5
