Workshop Practice and theory

MIDLANDS STATE UNIVERSITY

FACULTY OF GEOSCIENCES AND

ENGINEERING




Workshop Processes and
Practice
LECTURER:D.NDIYAMBA
Mechanical Engineering
HMECH112 Module

,Workshop Technology and Practice HMECH112

Module

,[Type here]

, Table of Figures
Figure 1: Fire Triangle 23
Figure 2: File Nomenclature 27
Figure 3: Cross Filing Stance (Source: Olivo) 28
Figure 4: Draw Filing (Source: Olivo) 29
Figure 5: File Card (Source: Olivo) 30
Figure 6: File Chalking (Source: Olivo) 30
Figure 7: File Safe Edge (Source: Olivo) 30
Figure 8: Flat File (Source: Olivo) 31
Figure 9: Hand File (Source: Olivo) 31
Figure 10: Round File (Source: Olivo) 32
Figure 11: Square File (Source: Olivo) 32
Figure 12: Half Round File (Source: Olivo) 32
Figure 13: Three Square File (Source: Olivo) 33
Figure 14: Knife Edge File (Source: Olivo) 33
Figure 15: Mill File (Source: Olivo) 33
Figure 16: Hammer Parts (Source: Olivo) 35
Figure 17: Ball Pein Hammer (Source: Olivo) 36
Figure 18: Cross Pein Hammer (Source: Olivo) 36
Figure 19: Straight Pein Hammer (Source: Olivo) 37
Figure 20: Centre Punch (Source: Olivo) 38
Figure 21: Dot Punched Holes (Source: Olivo) 39
Figure 22: Pin Punches (Source: Olivo) 39
Figure 23: Bell Punch (Source: Olivo) 40
Figure 24: Uses of Bell Punch (Source: Olivo) 41
Figure 25: Hacksaw Parts 41
Figure 26: Hacksaw Kerf (Source: Olivo) 43
Figure 27: Staggered and Wave Set 44
Figure 28: Vernier Caliper Parts (Source: Timings) 48
Figure 29: Digital Vernier Caliper 49
Figure 30: Uses of Vernier Calipers (Source: Timings) 49