1|Page
NYC MASTER ELECTRICIAN EXAM
(ELECTRICAL)Actual Exam Newest Actual Exam With
Complete 100 Questions And Correct Detailed
Answers||Verified Exam!!! (Verified Answers) |Already
Graded A+||Newest Exam!!!
Each general care area patient bed location in a
healthcare facility must be provided with four ____ or ____
duplex receptacles - Answers-Single or two
A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour
basis of ____ or more patients - Answers-Four
Where installed to reduce electrical noise for electronic
equipment, electrical continuity of the metal raceways
shall not be required and metal raceway can terminate a
(an) ____ nonmetallic fitting or spacer on electronic
equipment - Answers-Listed fitting
Feeder and branch circuit conductors within ____ inches
of a Ballast shall have an insulation temperature rating not
lower than 90°C (194°F) unless supplying a luminaiere
,2|Page
marked as suitable for a different insulation temperature -
Answers-3 inches
Manufactured wiring systems constructed with type MC
cable shall be supported and secured at intervals not
exceeding ____ ft. - Answers-6 ft
Where a main bonding jumper or a system bonding
jumper is a screw only the screw shall be identified with a
____ that shall be visible with the screw installed -
Answers-Green finish
Plug fuses a 15 amperes and lower rating shall be
identified by a ____ configuration of the window, cap, or
other prominent part to distinguish them from fuses of
higher ampere rating - Answers-Hexagon
The load for household electric clothes dryer's in a
dwelling unit(s) shall be either ____ watts (volt-amperes)
or the nameplate rating, which ever is larger, for each
dryer served ? - Answers-5000 watts
,3|Page
Service conductors installed as unjacketed multiconductor
cable shall have a minimum clearance of ____ windows
that are designed to be opened, doors, porches, stairs fire
escape or similar locations. - Answers-3 ft (36 inches)
—— Cartridge fuses of the renewable type shall be
permitted to be used only for replacement in existing
installation is where there is no evidence of over-fusing or
tampering. - Answers-Class H
Branch circuit conductors within ____inches of the ballast
shall have an insulation temperature rating not lower it
90°C 194°F - Answers-3" inches
The minimum radius of a field bend on trade size 1 "1/4
RMC is ____. - Answers-8
In a dwelling unit which appliance is allowed to have a
24"inch cord with Attachment ground plug ? - Answers-
Combination range hood/microwave oven
Type 3 Surge Protective devices can be installed on the
load side of a branch circuit overcurrent device up to the
, 4|Page
equipment served.if ____ the type 3 SPD connection must
be a minimum 30'ft of conductor a distance from the
service or separately derived system disconnect -
Answers-Included in the manufactures instructions
Which flexible cable is Allowed to be used for electric
vehicle charging station 300 Volts ? - Answers-EVJ
Type ____ fuse adapters shall be designed so that once
inserted in a fuse holder that cannot be removed -
Answers-Type S fuse
Service drops Installed over roof shall have a vertical
clearance of ____ above the roof surface, and unless a
lesser distance is permitted by and exceptions - Answers-
8'ft
Type ____ is multiconductor cable identified for use as
underground service entrance cable. - Answers-Type USE
cable
Knife switch rated for more than 1200 Amps at 250Volts or
less - Answers-Can be used only as isolating switch, shall
not be opened under load
NYC MASTER ELECTRICIAN EXAM
(ELECTRICAL)Actual Exam Newest Actual Exam With
Complete 100 Questions And Correct Detailed
Answers||Verified Exam!!! (Verified Answers) |Already
Graded A+||Newest Exam!!!
Each general care area patient bed location in a
healthcare facility must be provided with four ____ or ____
duplex receptacles - Answers-Single or two
A hospital is a building or portion thereof used for medical,
psychiatric,obstetrical , or surgical, care on a 24 hour
basis of ____ or more patients - Answers-Four
Where installed to reduce electrical noise for electronic
equipment, electrical continuity of the metal raceways
shall not be required and metal raceway can terminate a
(an) ____ nonmetallic fitting or spacer on electronic
equipment - Answers-Listed fitting
Feeder and branch circuit conductors within ____ inches
of a Ballast shall have an insulation temperature rating not
lower than 90°C (194°F) unless supplying a luminaiere
,2|Page
marked as suitable for a different insulation temperature -
Answers-3 inches
Manufactured wiring systems constructed with type MC
cable shall be supported and secured at intervals not
exceeding ____ ft. - Answers-6 ft
Where a main bonding jumper or a system bonding
jumper is a screw only the screw shall be identified with a
____ that shall be visible with the screw installed -
Answers-Green finish
Plug fuses a 15 amperes and lower rating shall be
identified by a ____ configuration of the window, cap, or
other prominent part to distinguish them from fuses of
higher ampere rating - Answers-Hexagon
The load for household electric clothes dryer's in a
dwelling unit(s) shall be either ____ watts (volt-amperes)
or the nameplate rating, which ever is larger, for each
dryer served ? - Answers-5000 watts
,3|Page
Service conductors installed as unjacketed multiconductor
cable shall have a minimum clearance of ____ windows
that are designed to be opened, doors, porches, stairs fire
escape or similar locations. - Answers-3 ft (36 inches)
—— Cartridge fuses of the renewable type shall be
permitted to be used only for replacement in existing
installation is where there is no evidence of over-fusing or
tampering. - Answers-Class H
Branch circuit conductors within ____inches of the ballast
shall have an insulation temperature rating not lower it
90°C 194°F - Answers-3" inches
The minimum radius of a field bend on trade size 1 "1/4
RMC is ____. - Answers-8
In a dwelling unit which appliance is allowed to have a
24"inch cord with Attachment ground plug ? - Answers-
Combination range hood/microwave oven
Type 3 Surge Protective devices can be installed on the
load side of a branch circuit overcurrent device up to the
, 4|Page
equipment served.if ____ the type 3 SPD connection must
be a minimum 30'ft of conductor a distance from the
service or separately derived system disconnect -
Answers-Included in the manufactures instructions
Which flexible cable is Allowed to be used for electric
vehicle charging station 300 Volts ? - Answers-EVJ
Type ____ fuse adapters shall be designed so that once
inserted in a fuse holder that cannot be removed -
Answers-Type S fuse
Service drops Installed over roof shall have a vertical
clearance of ____ above the roof surface, and unless a
lesser distance is permitted by and exceptions - Answers-
8'ft
Type ____ is multiconductor cable identified for use as
underground service entrance cable. - Answers-Type USE
cable
Knife switch rated for more than 1200 Amps at 250Volts or
less - Answers-Can be used only as isolating switch, shall
not be opened under load
