CFT MONITOR USMC FINAL STUDY GUIDE
2026 TESTED ANSWERS GRADED A+
⩥ Which equipment is required for a CFT?
Answer: Calibrated scale, dummy grenades, and measuring tape
⩥ As a CFT monitor, you must assist in the risk management(RM)
process for the CFT. Which of the following describes the RM process
steps?
Answer: Identifying hazards, assessing risks, determining which risks
are most important, implementing controls, and supervising the
participants
⩥ The CFT monitor is responsible for setting up the events, scoring
accurately, using proper equipment, and __________
Answer: ensuring participants wear the proper uniform
⩥ Which of the following are tasks performed by the CFT monitor
during an actual CFT?
Answer: Ensuring proper technique, calling out repetitions.
⩥ Location choices for the movement to contact event include outdoor
or indoor venue. What are the minimum location requirements you will
need to meet?
, Answer: Reasonable level, few to no obstacles
⩥ During the maneuver to contact event when may Marines remove
uniform blouses?
Answer: With the commander's authorization
⩥ As a CFT monitor, you have setup the movement to contact event on
an out-and-back route. The start and finish lines are the same. What is
the minimum number of monitors required for this route?
Answer: 3
⩥ The participant's goal during the movement to contact event is to
_______
Answer: finish as quickly as possible
⩥ SSgt Winifred Carter a 28-year-old female, ran the movement to
contact event in 3:18. What is her score for the movement to contact
event?
Answer: 95
⩥ What are the equipment requirements for ammunition cans used in the
ammunition lift event?
Answer: The contents should not move excessively when lifted, grip
tape applied to the can sides, and use M2A1 5.56mm cans only.
2026 TESTED ANSWERS GRADED A+
⩥ Which equipment is required for a CFT?
Answer: Calibrated scale, dummy grenades, and measuring tape
⩥ As a CFT monitor, you must assist in the risk management(RM)
process for the CFT. Which of the following describes the RM process
steps?
Answer: Identifying hazards, assessing risks, determining which risks
are most important, implementing controls, and supervising the
participants
⩥ The CFT monitor is responsible for setting up the events, scoring
accurately, using proper equipment, and __________
Answer: ensuring participants wear the proper uniform
⩥ Which of the following are tasks performed by the CFT monitor
during an actual CFT?
Answer: Ensuring proper technique, calling out repetitions.
⩥ Location choices for the movement to contact event include outdoor
or indoor venue. What are the minimum location requirements you will
need to meet?
, Answer: Reasonable level, few to no obstacles
⩥ During the maneuver to contact event when may Marines remove
uniform blouses?
Answer: With the commander's authorization
⩥ As a CFT monitor, you have setup the movement to contact event on
an out-and-back route. The start and finish lines are the same. What is
the minimum number of monitors required for this route?
Answer: 3
⩥ The participant's goal during the movement to contact event is to
_______
Answer: finish as quickly as possible
⩥ SSgt Winifred Carter a 28-year-old female, ran the movement to
contact event in 3:18. What is her score for the movement to contact
event?
Answer: 95
⩥ What are the equipment requirements for ammunition cans used in the
ammunition lift event?
Answer: The contents should not move excessively when lifted, grip
tape applied to the can sides, and use M2A1 5.56mm cans only.
