NICET Fire Alarm Level 1 Exam Questions and Answers with Verified
Solutions | Latest 2026 Update
Q: When a device is inaccessible due to excessive height, such as an atrium, what it the maximum
interval for testing?
Answer:
18 months
Q: When installing a wall-mounted fire telephone appliance to the public, what is the acceptable
maximum mounting height from the floor?
Answer:
66 inches
Q: Elevator lobby smoke detectors shall be mounted within a maximum of which distance from the
center-line of the door?
Answer:
21 feet
Q: At minimum, when working near power lines with voltage of 600 volts and lower, an aerial lift
operator shall maintain which distance from the lines?
Answer:
10 feet
Q: The use of unprotected EMT shall be permitted under which conditions?
Answer:
when in direct contact with the earth
Q: According to NFPA 70, what is the maximum unsupported length of 1/2-inch flexible metallic
conduit where flexibility is required after installation?
Answer:
4 1/2 feet
Q: What is the maximum bend (in degrees) permitted in a conduit run between outlet boxes?
Answer:
360 Degrees
, Q: If the primary power is disconnected and the fire alarm system goes into an alarm condition, what
is the minimum acceptable time for secondary power to operate the voice evacuation systems?
Answer:
15 minutes
Q: A riser room temperature switch should activate when the temperature falls below which level?
Answer:
40 degrees F
Q: According to NFPA 72, what is the maximum sound pressure level permitted in a space with
notification appliances?
Answer:
110 dBA
Q: What is the minimum interval for testing a single-station smoke detector in multifamily units?
Answer:
Annually
Q: Where should a technician install a detector in relation to beam that is less than 12 inches deep and
less that 8 feet in center?
Answer:
At the bottom of the beam
Q: An existing fire alarm cable in a drop ceiling will be spliced. which one of the following splice
locations will comply with NFPA 70?
Answer:
secured inside a listed box or enclosure
Q: Which function shall be tested for each newly installed smoke detector?
Answer:
smoke entry?
Q: An 180 foot long corridor is 10 feet wide, with a smooth 10 foot ceiling, interrupted by 4-inch
beams spaced every 10 feet. How many heat detectors with a listed 30 foot spacing are required?
Answer:
6 heat detectors
Solutions | Latest 2026 Update
Q: When a device is inaccessible due to excessive height, such as an atrium, what it the maximum
interval for testing?
Answer:
18 months
Q: When installing a wall-mounted fire telephone appliance to the public, what is the acceptable
maximum mounting height from the floor?
Answer:
66 inches
Q: Elevator lobby smoke detectors shall be mounted within a maximum of which distance from the
center-line of the door?
Answer:
21 feet
Q: At minimum, when working near power lines with voltage of 600 volts and lower, an aerial lift
operator shall maintain which distance from the lines?
Answer:
10 feet
Q: The use of unprotected EMT shall be permitted under which conditions?
Answer:
when in direct contact with the earth
Q: According to NFPA 70, what is the maximum unsupported length of 1/2-inch flexible metallic
conduit where flexibility is required after installation?
Answer:
4 1/2 feet
Q: What is the maximum bend (in degrees) permitted in a conduit run between outlet boxes?
Answer:
360 Degrees
, Q: If the primary power is disconnected and the fire alarm system goes into an alarm condition, what
is the minimum acceptable time for secondary power to operate the voice evacuation systems?
Answer:
15 minutes
Q: A riser room temperature switch should activate when the temperature falls below which level?
Answer:
40 degrees F
Q: According to NFPA 72, what is the maximum sound pressure level permitted in a space with
notification appliances?
Answer:
110 dBA
Q: What is the minimum interval for testing a single-station smoke detector in multifamily units?
Answer:
Annually
Q: Where should a technician install a detector in relation to beam that is less than 12 inches deep and
less that 8 feet in center?
Answer:
At the bottom of the beam
Q: An existing fire alarm cable in a drop ceiling will be spliced. which one of the following splice
locations will comply with NFPA 70?
Answer:
secured inside a listed box or enclosure
Q: Which function shall be tested for each newly installed smoke detector?
Answer:
smoke entry?
Q: An 180 foot long corridor is 10 feet wide, with a smooth 10 foot ceiling, interrupted by 4-inch
beams spaced every 10 feet. How many heat detectors with a listed 30 foot spacing are required?
Answer:
6 heat detectors
