Packet Tracer - Point-to-Point Single-Area OSPFv2 Configuration
Finish the Addressing Table:
Addressing Table
Device Interface IP Address Subnet Mask
R1 G0/0/0 192.168.10.1 /24
R1
S0/1/0 10.1.1.1 /30
R1
S0/1/1 10.1.1.5 /30
R2 G0/0/0 192.168.20.1 /24
R2
S0/1/0 10.1.1.2 /30
R2
S0/1/1 10.1.1.9 /30
R3 G0/0/0 192.168.30.1 /24
R3
S0/1/0 10.1.1.10 /30
R3
S0/1/1 /30
10.1.1.6
PC1 NIC 192.168.10.10 /24
PC2 NIC /24
192.168.20.10
PC3 NIC 192.168.30.10 /24
Objectives
Part 1: Configure Router IDs.
Part 2: Configure Networks for OSPF Routing.
Part 3: Configure Passive Interfaces.
Part 4: Verify OSPF configuration.
Background
In this activity, you will activate OSPF routing using network statements and wildcard masks, configuring
OSPF routing on interfaces, and by using network statements quad-zero masks. In addition, you will configure
explicit router IDs and passive interfaces.
Instructions
Part 1: Configure router IDs.
a. Start the OSPF routing process on all three routers. Use process ID 10.
Page 1 of 3
Finish the Addressing Table:
Addressing Table
Device Interface IP Address Subnet Mask
R1 G0/0/0 192.168.10.1 /24
R1
S0/1/0 10.1.1.1 /30
R1
S0/1/1 10.1.1.5 /30
R2 G0/0/0 192.168.20.1 /24
R2
S0/1/0 10.1.1.2 /30
R2
S0/1/1 10.1.1.9 /30
R3 G0/0/0 192.168.30.1 /24
R3
S0/1/0 10.1.1.10 /30
R3
S0/1/1 /30
10.1.1.6
PC1 NIC 192.168.10.10 /24
PC2 NIC /24
192.168.20.10
PC3 NIC 192.168.30.10 /24
Objectives
Part 1: Configure Router IDs.
Part 2: Configure Networks for OSPF Routing.
Part 3: Configure Passive Interfaces.
Part 4: Verify OSPF configuration.
Background
In this activity, you will activate OSPF routing using network statements and wildcard masks, configuring
OSPF routing on interfaces, and by using network statements quad-zero masks. In addition, you will configure
explicit router IDs and passive interfaces.
Instructions
Part 1: Configure router IDs.
a. Start the OSPF routing process on all three routers. Use process ID 10.
Page 1 of 3