FANUC ROBOT CERTIFICATION EXAM QUESTIONS WITH 100% CORRECT SOLUTIONS GUARANTEED SUCCESS.

FANUC ROBOTICS FINAL EXAM/CERT
When an adjustment is made using the Collision Guard Adjust Macro within a
Teach Pandant Program is this adjustment global or local change: Local
Global: Global
1. When Changing the robot's tooling or a payload is added, you must set a
new payload schedule (T/F): True
2. A Password is needed when making modifications to the DCS Settings
(T/F)-
: True
3. DCS stands for Dual Check Safety. What are the two items that are being
checked?
a) Position & Proper power-up
b) Position and Speed
c) Jog Coordinate & Speed: Position and Speed
5. If you receive a Cartesian position check error, how do you clear the error?

A)Hold down the SHIFT then press the Reset key
b) Press the RESET key
c)Cycle power: Hold down the SHIFT then press the Reset key
6. Prioritize the order on how to apply safety to the robotic system:
1) People
2) External Devices
3) Robot
4) Tooling
7. The Safety of the work area can be enhanced by installing the following
devices choose the appropriate ones from the list below:
1. Emergency stop buttons
2. Wooden Floor
3. Pressure mats
4. Box with sand




, FANUC ROBOTICS FINAL EXAM/CERT
Safety fences: Emergency stop buttons
pressure mats
saft
8. What devices are used in automated work cell to sense the pressure of a
human? choose all that apply:
Sensing devices
Light curtains
Presence sensing mat: Sensing devices
Light curtains
Presence sensing mat
9. Proximity sensing Devices use two main technologies: ultrasonic and laser
(T/F): True
10. The safety interlocks switch is one of the most important types of
protective devices because it interlocks the machine guard door with the
power source of the machine. When the guard door is opened, the door to
the machine is applied (T/F): False
11. choose the appropriate procedures when setting up a safe work cell:
Arrange the work cell so the operator faces the co-workers and not the robot
Install a lockout device uses an access code
Use anti-tie-down logic to prevent the operator from bypassing safety measures
Mount an adequate number of emergency stop button within easy reach of the operator
Position all controllers inside the robot work envelope
Always rely on the software as the primary safety element: Install a lockout device uses an
access code

Use anti-tie-down logic to prevent the operator from bypassing safety measures

Mount an adequate number of emergency stop button within easy reach of the operator






, FANUC ROBOTICS FINAL EXAM/CERT
12. From the list below choose the correct safety precautions allowing safe
teaching or manually operations of the robot: Never wear watches, rings,
scarves, or loose clothing

Start the robot immediately when enter the work cell
keep the area near the robot free of obstacles

run the robot in the production mode all the time: Never wear watches, rings, scarves, or
loose clothing

keep the area near the robot free of obstacles
13. From the list below choose the correct safety precautions allowing safe
automatic operation of the robot:
Make sure all personal is inside the work cell

Assume that a program is completed if the robot is not moving make sure all

safety provisions are present and active

allow another people enter the work cell during automatic operation know the entire

work cell area

Always stop the robot or break its motion with your body

if the robot is running in a pattern, assume that it will continue to run the same pattern:
Make sure all personal is inside the work cell

know the entire work cell area
14. From the list below choose the correct safety precautions allowing safe
inspection of the robot:
Turn on power at the controller