MASS 2A-1C Hoisting Exam Questions With 100% Correct Answers | Updated 2026 | Graded A+

MASS 2A-1C Hoisting Exam Questions With 100% Correct Answers | Updated 2026 | Graded A+ How many pounds in a ton? - answer-2000 pounds What type of equipment requires a H/H license in Mass? - answer-10 feet or either, 1/4 cu/yd 500 pounds What type of system is used when working on de-energized circuitry? - answer-Lock out/Tag out All welding and cutting on hoisting equipment must be done in accordance with what code? - answer- 1998 ASME Chapter IX What type of protection is required for hoisting operation? - answer-ROPS, Heat, Seatbelts, Shatterproof Glass, and Hardhats What regulatory authority governs hoisting in Mass? - answer-520 CMR 6.00 What does CMR stand for? - answer-Code of Massachusetts Regulation What chapter applies to Hoisting? - answer-Chapter 146 section 53-54A When loading a 10 wheeler; how do you approach the truck? - answer-Low and Slow, load front to back How do you carry the load? - answer-Close to the groundHow close can you mechanically dig to a known utility? - answer-18" When driving a loader down hill, what should you not do? - answer-Raise the bucket or put the machine in neutral When filling a trench should you use the backhoe bucket in a sweeping motion? - answer-No it can cause mechanical failure What are supper extensions used for? - answer-To dig deeper When rowing, not trailing a backhoe or ladder; what speed should you not exceed? - answer-5 mph What does articulate mean on a wheel loader? - answer-Bends in the middle What is the "slow moving triangle" and what speed can they not exceed? - answer-Red triangle with orange center, 25 mph What is coupling the brakes? - answer-Locking the brakes together, used when traveling on the road Can you run a machine inside a building? - answer-Yes with scrubbers, adequate ventilation, and monitoring Scavenging air is what? - answer-Taking in air naturally Supercharging air is what? - answer-Supercharging air is forcing in air How does fuel in a gas engine ignite? - answer-Heat, Spark and Combustion What OSHA rules govern rigging equipment? - answer-OSHA 1926.251What does a governor do on a engine? - answer-Controls the RPM What causes starving on a hydraulic system? - answer-Low fluid, dirty filter,leak, or kinked hoses Name 5 requirements for refueling hoisting equipment? - answer-Shut off the engine, transmission in Neutral, set the brake, no smoking and ensure all parts are lowered to the ground May chains be used afore hoisting? - answer-No, only chain slings What do you look for before setting up a lull for pick? - answer-Power lines, Soft areas, Workers, Grates and Moving Vechicles What do you look for before digging? - answer-Soft soil, wet areas, power lines, dig safe marks, Wells, lights, "read the street" What do you do with open trenches at the end of the day? - answer-Protect the public from the trench i.e. Jackie's Law What is the purpose of a thimble in rigging? - answer-It stops the loop from crushing What is the proper way to exit a machine? - answer-3 points of contact What is the 3 point of contact? - answer-Two feet one hand, or two hands one foot, on the ladder at all time What restricts the machines lifting capacity? - answer-The load chart, the pressure relief valve, and the manufactures specification What is the most common way an operator is injured? - answer-Falls off the equipment