Virginia HIC Exam
Save
Practice questions for this set
Learn
Studied 7 terms
Nice work, you're crushing it
Continue studying in Learn
Terms in this set (124)
The MOST specific information Floor plan
about the size and location of
windows would be found in a
What direction does heat flow? Hot to cold
What are batter boards stakes and ledger boards marking building lines
What is the MAXIMUM distance 3 feet
between a ventilating opening in an
under-floor space and each corner
of the building?
, What is NOT required in exterior Load-bearing headers
nonbearing walls?
A lengthwise grain separation Shake (c 326)
between or through the growth
rings of lumber is called a
The abbreviation "d" in "16d" means Penny
Notches may not be located in the Middle 1/3
____________ of a joist span
How should board and batten be 1 inch overlap 10d nails
installed?
What is the maximum allowable 1/6 the depth of the member
notch in ceiling joists
How MUST rafters be framed to Gusset plate (R802.3)
each other
What is used to prevent buckling at Squash blocks
points of high stress?
Prior to the installation of wood 4-5 days
floor how long for acclimation?
Where do you start laying parquet Centerline
flooring
What is the first step in carpet Tackless strip
installation?
What type of nail is used in floor 7d or 8d threaded/Cut steel
installation
Save
Practice questions for this set
Learn
Studied 7 terms
Nice work, you're crushing it
Continue studying in Learn
Terms in this set (124)
The MOST specific information Floor plan
about the size and location of
windows would be found in a
What direction does heat flow? Hot to cold
What are batter boards stakes and ledger boards marking building lines
What is the MAXIMUM distance 3 feet
between a ventilating opening in an
under-floor space and each corner
of the building?
, What is NOT required in exterior Load-bearing headers
nonbearing walls?
A lengthwise grain separation Shake (c 326)
between or through the growth
rings of lumber is called a
The abbreviation "d" in "16d" means Penny
Notches may not be located in the Middle 1/3
____________ of a joist span
How should board and batten be 1 inch overlap 10d nails
installed?
What is the maximum allowable 1/6 the depth of the member
notch in ceiling joists
How MUST rafters be framed to Gusset plate (R802.3)
each other
What is used to prevent buckling at Squash blocks
points of high stress?
Prior to the installation of wood 4-5 days
floor how long for acclimation?
Where do you start laying parquet Centerline
flooring
What is the first step in carpet Tackless strip
installation?
What type of nail is used in floor 7d or 8d threaded/Cut steel
installation
