1|Page
DCOM 219 FINAL EXAM LATEST 2026 ACTUAL EXAM WITH
COMPLETE QUESTIONS AND CORRECT DETAILED ANSWERS (100%
VERIFIED ANSWERS) |ALREADY GRADED A+| ||PROFESSOR
VERIFIED|| ||BRANDNEW!!!||
Which three options must match in order to establish an
EtherChannel between two directly connected switches? (Choose
three.) - ANSWER-duplex settings of the interfaces that are used
for EtherChannel
VLAN memberships of the interfaces that are used for
EtherChannel
speed of the interfaces that are used for EtherChannel
Which two protocols are used to implement EtherChannel?
(Choose two.) - ANSWER-Link Aggregation Control Protocol
Port Aggregation Protocol
In FHRP terminology, what represents a set of routers that
present the illusion of a single router to hosts? - ANSWER-virtual
router
,2|Page
Which command must be used on SW2 to enable this
EtherChannel? - ANSWER-SW2(config-if-range)# channel-group
1 mode desirable
An EtherChannel link using LACP was formed between two
switches, S1 and S2. While verifying the configuration, which
mode combination could be utilized on both switches? -
ANSWER-S1-passive and S2-active
Which statement describes a characteristic of EtherChannel? -
ANSWER-It is made by combining multiple physical links that are
seen as one link between two switches.
Refer to the exhibit. Which switching technology would allow each
access layer switch link to be aggregated to provide more
bandwidth between each Layer 2 switch and the Layer 3 switch? -
ANSWER-EtherChannel
Which statement is true regarding the use of PAgP to create
EtherChannels? - ANSWER-It is Cisco proprietary.
,3|Page
Refer to the exhibit. A network administrator has decided that an
EtherChannel between ports 0/1 and 0/2 on switches S1 and S2
would help performance. After making the configuration, the
administrator notices no performance gain. Based on the output
that is shown, what two possible assumptions could a network
administrator make? (Choose two.) - ANSWER-One of the ports
on S2 was not configured correctly.
The EtherChannel bundle is not working.
Which nonproprietary protocol provides router redundancy for a
group of routers which support IPv4 LANs? - ANSWER-VRRPv2
A network administrator is configuring an EtherChannel link
between switches SW1 and SW2 by using the command
SW1(config-if-range)# channel-group 1 mode passive. Which
command must be used on SW2 to enable this EtherChannel? -
ANSWER-SW2(config-if-range)# channel-group 1 mode active
Which routing protocol is designed to use areas to scale large
hierarchical networks? - ANSWER-OSPF
, 4|Page
Which routing protocol uses link-state information to build a map
of the topology for computing the best path to each destination
network? - ANSWER-OSPF
After a network topology change occurs, which distance vector
routing protocol can send an update message directly to a single
neighboring router without unnecessarily notifying other routers? -
ANSWER-EIGRP
Which dynamic routing protocol was developed as an exterior
gateway protocol to interconnect different Internet providers? -
ANSWER-BGP
A network administrator is researching routing protocols for
implementation in a critical network infrastructure. Which protocol
uses the DUAL algorithm to provide almost instantaneous
convergence during a route failover? - ANSWER-EIGRP
Which routing protocol sends a routing update to neighboring
routers every 30 seconds? - ANSWER-RIP
DCOM 219 FINAL EXAM LATEST 2026 ACTUAL EXAM WITH
COMPLETE QUESTIONS AND CORRECT DETAILED ANSWERS (100%
VERIFIED ANSWERS) |ALREADY GRADED A+| ||PROFESSOR
VERIFIED|| ||BRANDNEW!!!||
Which three options must match in order to establish an
EtherChannel between two directly connected switches? (Choose
three.) - ANSWER-duplex settings of the interfaces that are used
for EtherChannel
VLAN memberships of the interfaces that are used for
EtherChannel
speed of the interfaces that are used for EtherChannel
Which two protocols are used to implement EtherChannel?
(Choose two.) - ANSWER-Link Aggregation Control Protocol
Port Aggregation Protocol
In FHRP terminology, what represents a set of routers that
present the illusion of a single router to hosts? - ANSWER-virtual
router
,2|Page
Which command must be used on SW2 to enable this
EtherChannel? - ANSWER-SW2(config-if-range)# channel-group
1 mode desirable
An EtherChannel link using LACP was formed between two
switches, S1 and S2. While verifying the configuration, which
mode combination could be utilized on both switches? -
ANSWER-S1-passive and S2-active
Which statement describes a characteristic of EtherChannel? -
ANSWER-It is made by combining multiple physical links that are
seen as one link between two switches.
Refer to the exhibit. Which switching technology would allow each
access layer switch link to be aggregated to provide more
bandwidth between each Layer 2 switch and the Layer 3 switch? -
ANSWER-EtherChannel
Which statement is true regarding the use of PAgP to create
EtherChannels? - ANSWER-It is Cisco proprietary.
,3|Page
Refer to the exhibit. A network administrator has decided that an
EtherChannel between ports 0/1 and 0/2 on switches S1 and S2
would help performance. After making the configuration, the
administrator notices no performance gain. Based on the output
that is shown, what two possible assumptions could a network
administrator make? (Choose two.) - ANSWER-One of the ports
on S2 was not configured correctly.
The EtherChannel bundle is not working.
Which nonproprietary protocol provides router redundancy for a
group of routers which support IPv4 LANs? - ANSWER-VRRPv2
A network administrator is configuring an EtherChannel link
between switches SW1 and SW2 by using the command
SW1(config-if-range)# channel-group 1 mode passive. Which
command must be used on SW2 to enable this EtherChannel? -
ANSWER-SW2(config-if-range)# channel-group 1 mode active
Which routing protocol is designed to use areas to scale large
hierarchical networks? - ANSWER-OSPF
, 4|Page
Which routing protocol uses link-state information to build a map
of the topology for computing the best path to each destination
network? - ANSWER-OSPF
After a network topology change occurs, which distance vector
routing protocol can send an update message directly to a single
neighboring router without unnecessarily notifying other routers? -
ANSWER-EIGRP
Which dynamic routing protocol was developed as an exterior
gateway protocol to interconnect different Internet providers? -
ANSWER-BGP
A network administrator is researching routing protocols for
implementation in a critical network infrastructure. Which protocol
uses the DUAL algorithm to provide almost instantaneous
convergence during a route failover? - ANSWER-EIGRP
Which routing protocol sends a routing update to neighboring
routers every 30 seconds? - ANSWER-RIP
