J-STD-001
Save
Practice questions for this set
Learn
Studied 7 terms
Nice work, you're crushing it
Continue studying in Learn
Terms in this set (87)
Who is responsible for identifying User
the assembly class?
What is a defect? A condition that may affect the form, fit, or function
of the item in the end use environment
Hardware found to not conform to [D1D2D3]
the requirements of the standard
shall be classified as defects and
dispositioned for:
, There shall be no broken strands for [D1D2D3]
wires used at a potential of 6kV or
greater:
A documented process control [N1N2D3]
system shall be implemented for:
The contract shall take precedence [D1D2D3]
over this standard for:
What is wire overlap? When a wire is wrapped more than 360 and
crosses over itself
What is wire over wrap? When a wire is wrapped more than 360 and
remains in contact with the terminal
Manufacturers shall perform 100% [N1D2D3]
inspection unless sampling
inspection is defined for:
Inspection of soldering and [N1D2D3]
cleanliness shall be performed prior
to conformal coasting, staking, or
encapsulation for:
Illumination at the surface of work 1000 lux
stations should be at least what?
What is the tolerance for +- 15%
magnification aids?
Save
Practice questions for this set
Learn
Studied 7 terms
Nice work, you're crushing it
Continue studying in Learn
Terms in this set (87)
Who is responsible for identifying User
the assembly class?
What is a defect? A condition that may affect the form, fit, or function
of the item in the end use environment
Hardware found to not conform to [D1D2D3]
the requirements of the standard
shall be classified as defects and
dispositioned for:
, There shall be no broken strands for [D1D2D3]
wires used at a potential of 6kV or
greater:
A documented process control [N1N2D3]
system shall be implemented for:
The contract shall take precedence [D1D2D3]
over this standard for:
What is wire overlap? When a wire is wrapped more than 360 and
crosses over itself
What is wire over wrap? When a wire is wrapped more than 360 and
remains in contact with the terminal
Manufacturers shall perform 100% [N1D2D3]
inspection unless sampling
inspection is defined for:
Inspection of soldering and [N1D2D3]
cleanliness shall be performed prior
to conformal coasting, staking, or
encapsulation for:
Illumination at the surface of work 1000 lux
stations should be at least what?
What is the tolerance for +- 15%
magnification aids?
