Michigan State Brakes Certification Exam Solved 100% Correct 2026
1. Most 1995 & newer vehicles use which of Sealed non-serviceable
the following types of wheels bearings on
non-drive wheel?
2. to test a vacuum power brake booster in the drop slightly and remain firm
vehicle, you should pump the brake ped-
al at least 4 times, hold the brake pedal
depressed, and start the engine. the brake
pedal should:
3. You are installing a set of brake shoe linings Smaller and goes towards the front of the
that are not the same length. Traditionally, car.
the primary shoe lining is:
4. A cracked or torn vacuum diaphragm in a hard pedal feel requiring very high pedal
a brake power booster would most likely ettort to stop
cause:
5. Which of the following incorrect service master cylinder push rod adjusted too long
procedures will cause brake lock-up?
6. Which of the following describes the proper Pump the brake pedal at least 25 times
way to depressurized an ABS system? (or more, depending on the manufacturer's
recommendation) with the ignition ott.
7. The rear brakes are dragging after having technician use the parking brake to adjust
new linings installed and the drums ma- shoes and the cable is stuck
chined. the most likely cause is the:
8. On a 3-channel system, which wheels are both rear wheels
on the same circuit?
9. wheel speed sensors
1/4
1. Most 1995 & newer vehicles use which of Sealed non-serviceable
the following types of wheels bearings on
non-drive wheel?
2. to test a vacuum power brake booster in the drop slightly and remain firm
vehicle, you should pump the brake ped-
al at least 4 times, hold the brake pedal
depressed, and start the engine. the brake
pedal should:
3. You are installing a set of brake shoe linings Smaller and goes towards the front of the
that are not the same length. Traditionally, car.
the primary shoe lining is:
4. A cracked or torn vacuum diaphragm in a hard pedal feel requiring very high pedal
a brake power booster would most likely ettort to stop
cause:
5. Which of the following incorrect service master cylinder push rod adjusted too long
procedures will cause brake lock-up?
6. Which of the following describes the proper Pump the brake pedal at least 25 times
way to depressurized an ABS system? (or more, depending on the manufacturer's
recommendation) with the ignition ott.
7. The rear brakes are dragging after having technician use the parking brake to adjust
new linings installed and the drums ma- shoes and the cable is stuck
chined. the most likely cause is the:
8. On a 3-channel system, which wheels are both rear wheels
on the same circuit?
9. wheel speed sensors
1/4
