SOS Mechanic Certification- Brakes Exam with
correct Answers
Save
Terms in this set (83)
Most 1995 & newer vehicles use Sealed non-serviceable
which of the following types of
wheels bearings on non-drive
wheel?
to test a vacuum power brake drop slightly and remain firm
booster in the vehicle, you should
pump the brake pedal at least 4
times, hold the brake pedal
depressed, and start the engine. the
brake pedal should:
You are installing a set of brake Smaller and goes towards the front of the car.
shoe linings that are not the same
length. Traditionally, the primary
shoe lining is:
A cracked or torn vacuum a hard pedal feel requiring very high pedal effort
diaphragm in a brake power to stop
booster would most likely cause:
A mechanic finds gear lube inside A plugged axle
both rear brake drums on a rear
wheel drive vehicle. What is the
most likely cause of this problem?
, Which of the following incorrect master cylinder push rod adjusted too long
service procedures will cause brake
lock-up?
Which of the following describes Pump the brake pedal at least 25 times (or more,
the proper way to depressurized an depending on the manufacturer's
ABS system? recommendation) with the ignition off.
The rear brakes are dragging after technician use the parking brake to adjust shoes
having new linings installed and the and the cable is stuck
drums machined. the most likely
cause is the:
When turning brake drums: use a dampening strap to reduce chatter
Which of the following is NOT a run-out
necessary drum brake
measurement?
On a 3-channel system, which both rear wheels
wheels are on the same circuit?
One way to test an ABS wheel AC volts
speed signal is to use _____ on your
digital multimeter.
The key input for the ABS control wheel speed sensors
module comes from the:
ABS speed sensor and sensor rings: should not be hammered or tapped on and
should always be replaced as a matched set
Flexible brake hoses should be when dampness is evident on the hose
replaced:
correct Answers
Save
Terms in this set (83)
Most 1995 & newer vehicles use Sealed non-serviceable
which of the following types of
wheels bearings on non-drive
wheel?
to test a vacuum power brake drop slightly and remain firm
booster in the vehicle, you should
pump the brake pedal at least 4
times, hold the brake pedal
depressed, and start the engine. the
brake pedal should:
You are installing a set of brake Smaller and goes towards the front of the car.
shoe linings that are not the same
length. Traditionally, the primary
shoe lining is:
A cracked or torn vacuum a hard pedal feel requiring very high pedal effort
diaphragm in a brake power to stop
booster would most likely cause:
A mechanic finds gear lube inside A plugged axle
both rear brake drums on a rear
wheel drive vehicle. What is the
most likely cause of this problem?
, Which of the following incorrect master cylinder push rod adjusted too long
service procedures will cause brake
lock-up?
Which of the following describes Pump the brake pedal at least 25 times (or more,
the proper way to depressurized an depending on the manufacturer's
ABS system? recommendation) with the ignition off.
The rear brakes are dragging after technician use the parking brake to adjust shoes
having new linings installed and the and the cable is stuck
drums machined. the most likely
cause is the:
When turning brake drums: use a dampening strap to reduce chatter
Which of the following is NOT a run-out
necessary drum brake
measurement?
On a 3-channel system, which both rear wheels
wheels are on the same circuit?
One way to test an ABS wheel AC volts
speed signal is to use _____ on your
digital multimeter.
The key input for the ABS control wheel speed sensors
module comes from the:
ABS speed sensor and sensor rings: should not be hammered or tapped on and
should always be replaced as a matched set
Flexible brake hoses should be when dampness is evident on the hose
replaced:
