If a pressure gauge in a pneumatic circuit reads gauge pressure of 480 kPa (69.62 psig),
what is the absolute pressure in the circuit assuming the circuit is at sea level?
Give this one a go later!
480 kPa (69.62 psig) 2 380 kpa (55.12 psig)
3 580 kpa (84.12 psig) 4 485 kpa (70.35 psig)
Press any key to
Don't know?Continue
continue
Terms in this set (38)
What happens if the air temperature in a Pipes will Freeze
pneumatic system drops below the dew point?
In a compressed air system, what carries lubricant Air flow
from an air lubricator to the points of use?
What method is most commonly used to drip rate shown in sight dome
determine the flow rate of lubricant being
dispensed by an air lubricator?
, What is Delta P? Pressure difference between two pints in pneumatic system
What setting on a compressor pressure switch Minimum pressure
must e adjusted to keep the compressor from
constantly cycling?
What type of operator is used on this directional Manual
control valve?
In the circuit shown, if the reading on Gauge 2 is The Same
300 kPa, what is the reading on Gauge 3,
assuming the valve is in a de-energized state?
For what purpose is the pneumatic regulator to provide a constant pressure to the circuit
used?
Why should you avoid blocking a pressurized air The air can penetrate the skin
line with your fingers or hands?
What do MOST industrial pneumatic systems use Air
to transmit energy?
What is the function of a needle valve in a Control flow rate
pneumatic circuit?
what is the absolute pressure in the circuit assuming the circuit is at sea level?
Give this one a go later!
480 kPa (69.62 psig) 2 380 kpa (55.12 psig)
3 580 kpa (84.12 psig) 4 485 kpa (70.35 psig)
Press any key to
Don't know?Continue
continue
Terms in this set (38)
What happens if the air temperature in a Pipes will Freeze
pneumatic system drops below the dew point?
In a compressed air system, what carries lubricant Air flow
from an air lubricator to the points of use?
What method is most commonly used to drip rate shown in sight dome
determine the flow rate of lubricant being
dispensed by an air lubricator?
, What is Delta P? Pressure difference between two pints in pneumatic system
What setting on a compressor pressure switch Minimum pressure
must e adjusted to keep the compressor from
constantly cycling?
What type of operator is used on this directional Manual
control valve?
In the circuit shown, if the reading on Gauge 2 is The Same
300 kPa, what is the reading on Gauge 3,
assuming the valve is in a de-energized state?
For what purpose is the pneumatic regulator to provide a constant pressure to the circuit
used?
Why should you avoid blocking a pressurized air The air can penetrate the skin
line with your fingers or hands?
What do MOST industrial pneumatic systems use Air
to transmit energy?
What is the function of a needle valve in a Control flow rate
pneumatic circuit?
