CSWA solidworks certification Exam | 2026/2027 Most
Recent Exam Actual Complete Real Exam Questions
And 100%Correct Answers (Verified Answers) Already
Graded A+ | Guaranteed Success!! | Newest Exam |
Brand New!!
True or False - Dragging the edge of plane changes its
geometric size. - ANSWER-False
______are commonly used for drawing with rotational
symmetry such as wheels or flanges that have holes or
other features arrayed in a circular pattern. - ANSWER-
Aligned Section View
,In an aligned section view, if a standard section line
cannot be drawn vertically or horizontally to go through the
center of a feature then______ is used that does not line
up with the parent view.: - ANSWER-angled section line
: Cut away a portion of an assembly in order to expose the
inside.
emplate. - ANSWER-Broken-Out Section View
: Show portions of a model that are difficult to see in the
parent view. - ANSWER-Detail View
, : Define views by selecting any face from the model that
does not require a parent view or have a view arrow. -
ANSWER-Relative to Model View
: Create a break/gap in a model so that the view can fit on
a smaller drawing sheet. - ANSWER-Break View
: Creates 3 default orthographic views of the model (Top,
Front, Right Side). - ANSWER-Standard 2 View
: Omit a portion of a view and are enclosed using a sketch,
such as a spline, and is similar to a detail view but does
not create an additional zoomed in view. - ANSWER-Crop
View
Recent Exam Actual Complete Real Exam Questions
And 100%Correct Answers (Verified Answers) Already
Graded A+ | Guaranteed Success!! | Newest Exam |
Brand New!!
True or False - Dragging the edge of plane changes its
geometric size. - ANSWER-False
______are commonly used for drawing with rotational
symmetry such as wheels or flanges that have holes or
other features arrayed in a circular pattern. - ANSWER-
Aligned Section View
,In an aligned section view, if a standard section line
cannot be drawn vertically or horizontally to go through the
center of a feature then______ is used that does not line
up with the parent view.: - ANSWER-angled section line
: Cut away a portion of an assembly in order to expose the
inside.
emplate. - ANSWER-Broken-Out Section View
: Show portions of a model that are difficult to see in the
parent view. - ANSWER-Detail View
, : Define views by selecting any face from the model that
does not require a parent view or have a view arrow. -
ANSWER-Relative to Model View
: Create a break/gap in a model so that the view can fit on
a smaller drawing sheet. - ANSWER-Break View
: Creates 3 default orthographic views of the model (Top,
Front, Right Side). - ANSWER-Standard 2 View
: Omit a portion of a view and are enclosed using a sketch,
such as a spline, and is similar to a detail view but does
not create an additional zoomed in view. - ANSWER-Crop
View
