Detailed Answers
NAVAIR 11-140-7 correct answers Pyrotechnics publication
NAVAIR 11-140-6.1 correct answers Air-to-air missiles publication
What information do you look for when asked to inventory ordnance? correct answers NALC,
NIIN, Nomenclature, Lot/Serial number, Quantity (QTY), Condition Code (C/C), and
Maintenance Due Date (MDD)
What sections are the same in every WAM Manual? correct answers (1) Introduction, (2)
Description, (3) Configuration, (4) Testing, (5) Common Procedures
In any NAVAIR manual what does a WARNING mean? correct answers An operating procedure
or practice which, if not correctly followed, could result in personnel injury or loss of life
What is the CV NATOPS manual? correct answers NAVAIR 00-80T-105
What publication provides instructions for building Defect Codes? correct answers NAVSUP
P805, Appendix D
In any NAVAIR manual what does a NOTE mean? correct answers An operating procedure or
condition which is essential to highlight
What chapter of CV NATOPS pertains to ordnance? correct answers 7
What are the HERO manuals? correct answers OP 3565 and NAVAIR 16-1-529
, If there is a conflict between the pub and the checklist which one takes precedence , and how do
I find it? correct answers The one with the most current date, you find that in the Introduction
section of the checklist.
What is the EEA of an AIM-9X? correct answers The White Line on the safe selector will be in
the armed position.
What is the AWSE configuration manual? correct answers NAVAIR 11-140-25
What must be written on all CADs, certain fuzes, and certain proximity sensors? correct answers
Open date in inedible marker.
On a TALD what can happen if the electrical safing pin is not installed? correct answers
Inadvertent firing of chaff or activation of RF module may occur.
What is the WAM for GBUs? correct answers NAVAIR 11-140-10
What is the difference between SHELF life and SERVICE life? correct answers Shelf: life of
weapon from manufacturer while sealed in its original container never being opened.
Service: life of a weapon once manufacturer seal has been broken and container has been
opened.
What is the EEA of the AGM-88? correct answers The arming key (T handle) will be moved to
the arm position or not be present.
What is the WAM for AIMs? correct answers NAVAIR 11-140-6.1